Weslo Cadence 340cs English Manual - Page 6
Handrails 4, 88. Thread four Console Screws 3 into - treadmill parts
View all Weslo Cadence 340cs manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3. Hold the Console Base (87) near the right Handrail (4). Make a loop with the indicated plastic tie, and insert the two Wires (53) through the loop. Pull out just enough of the Wires to connect them to the two connectors in the Console Base (87). Plug the Wires into the connectors. Important: Make sure that the Wires are fully inserted. WARNING: Do not disconnect or connect the Wires while the treadmill power cord is plugged in. Refer drawing 3a. Set the Console Base (87) on the Handrails (4, 88). Thread four Console Screws (3) into the Handrails and the Console Base. After all four Screws have been started, tighten the Screws until they are snug; do not overtighten the Screws. Feed the excess Wire Harness (53) into the upper end of the right Handrail (4). Pull the plastic tie tight and cut off the end. 4. Attach the Storage Latch (16) to the left Upright (38) with two Latch Screws (14). Refer to step 2. Tighten the four Handrail Bolts (1). 3 Plastic Tie 4 3a 4 Plastic Tie 4 53 87 87 53 3 88 3 38 16 14 5. Hold a Weight Rack (15) against the right Upright (38) in the position shown. Loosely thread two Rack Screws (14) into the bottom holes in the Weight Rack and the 5 38 Upright. Next, loosely thread four Rack Screws into the other four holes. Then, tighten all six Rack Screws. Set a 3-lb. Weight (not shown) on the bottom hanger on the Weight Rack (15), a 2-lb. Weight on the middle hanger, and a 1-lb. Weight on the top hanger. Attach the other Weight Rack and Weights to the left Upright in the same way (not shown). 15 14 14 Hanger 14 6. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill. 6