Weslo Cadence 400cs English Manual - Page 8

Caution - key

Page 8 highlights

CONSOLE DIAGRAM Note: If there is a thin sheet of clear plastic on the console, remove it before operating the console. CAUTION: Before operating the console, read the following precautions. • Do not stand on the walking belt when turning on the power. • Always wear the clip (see the drawing at the lower right) while using the treadmill. When the key is removed from the console, the walking belt will stop. • Adjust the speed in small increments. • The training zones marked beside the speed control are general guidelines only. See page 14 for more information. • To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle. BATTERY INSTALLATION The console requires three "AA" batteries (not included). Alkaline batteries are recommended. Open the battery cover as shown in the drawing at the upper right. Insert the batteries into the console, making sure that the negative (-) ends of the batteries are touching the springs in the console. Battery Cover Batteries Tab Close the battery cover, push up on the battery cover tab, and then push the tab forward as shown in the inset drawing. Make sure that the tab locks into place. STEP-BY-STEP CONSOLE OPERATION Before operating the console, make sure that the power cord is properly plugged in (see page 7). Stand on the foot grips of the treadmill. Find the clip Clip attached to the key and slide the clip onto the waist- band of your clothing. Next, insert the key into the con- sole. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19

BATTERY INSTALLATION
The console requires three "AA" batteries
(not in-
cluded). Alkaline batteries are recommended. Open
the battery cover as shown in the drawing at the upper
right. Insert the batteries into the console, making sure
that the negative (–) ends of the batteries are touching
the springs in the console.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
inset drawing. Make sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in (see page 7).
Stand on the foot grips of
the treadmill. Find the clip
attached to the key and
slide the clip onto the waist-
band of your clothing. Next,
insert the key into the con-
sole.
Test the clip by carefully taking a few steps
backward until the key is pulled from the console.
If the key is not pulled from the console, adjust the
position of the clip as needed.
CAUTION:
Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing at
the lower right) while using the treadmill.
When the key is removed from the console,
the walking belt will stop.
• Adjust the speed in small increments.
• The training zones marked beside the
speed control are general guidelines only.
See page 14 for more information.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
Battery
Cover
Tab
CONSOLE DIAGRAM
Note: If there is a thin sheet of clear plastic
on the console, remove it before operating
the console.
Clip
Batteries
8