Weslo Cadence 700 Treadmill Uk Manual - Page 9

9. Insert the excess Wire Harness (60) into the large hole in the side of the Right Handrail (59). Securely tighten the plastic ties on the bottom of the Console Base (52) to prevent the Wire Harness from slipping. Then, cut off the ends of the plastic ties. Route the Wire Harness (60) through the indicated opening in the Console Base (52). Attach the Wire Cover (54) to the Console Base with a 1/2" Silver Screw (90). Tighten two 3/4" Screws (2) into the Console Base (52). Tighten the two Crossbar Screws (92). 9 Ties Opening 52 60 54 59 92 90 2 10. Lower the Handrails (53, 59) until they are touching the 10 floor. See 10a. Position the Handrails (53, 59) so the treadmill Frame (79) is centered between them. Firmly tighten the four 2 1/2" Bolts (65), the two 2" Bolts (62), and the two 4" Bolts (70). Be careful not to over- tighten the Bolts. 10a 65 53, 59 70 62 79 65 Top View 59 53 79 11. Orient the Latch Housing (48) so the large hole is on the 11 indicated side. Attach the Latch Housing to the Left Handrail (53) with two 3/4" Screws (2); start both Latch Screws and then tighten them. Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (48). Then, tighten the knob back onto the pin. 2 Knob 48 Spring Collar Pin 53 Large Hole 12. Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see page 18). To protect the floor or carpet, place a mat under the treadmill. 9