Weslo Cadence 930 Treadmill English Manual - Page 9
reading.If
View all Weslo Cadence 930 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
STEP BY STEP CONSOLE OPERATION Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7.) Step onto the foot rails of the treadmill. Next, find the clip attached to the key (see the drawing on page 8). Slide the clip onto the waistband of your clothing Follow the steps below to operate the console. Insert the key fully into the power switch. Inserting the key will not turn on the displays. The displays will turn on ATION 0 INSERT KIT when the ON/RESET (or ON/CLEAR) button is pressed or when the /I\ walking belt is started. Note: If you just installed batteries, the displays will already be on. Reset the speed control. Turn the speed con- trol counterclock- SPUD TZAR...PPG ZONES wise to the RESET so" position. Note: Each time the walking belt is stopped, the speed control must be turned to the RESET position before the walking belt can be restarted. Start the walking belt. After you have turned the speed control to the RESET position, slowly turn it clockwise until the walking belt begins to move at slow speed. Carefully step onto the walking belt and begin exercising. Change the speed of the walking belt as desired by turning the speed control. To stop the walking belt, step onto the foot rails and turn the speed control to the RESET position. 4 Follow your progress with the monitor displays. DISTANCE display- This display shows the total distance that you have walked or run, in miles. DISTANCE TIME display-This display shows the total time that you have walked or run on the treadmill. CALORIES display- This display shows the approximate number of calories you have burned. SPEED display-This display shows the speed of the walking belt, in miles per hour. TIME 1 =1 LI I -I 1 CALORIES SPEED The displays can be reset, if desired, by pressing the ON/RESET (or ON/CLEAR) button. 0 ON/RESET Measure your pulse, if desired. To use the pulse sensor, stand on the foot rails and place your thumb on the pulse sensor as shown. The pulse sensor Pulse Sensor is pressure-acti- 0 .6> vated; fully press down the pulse sensor. Do not press too hard, or the circula- tion in your thumb will be restricted, and your pulse will not be detected. Next, slightly raise your thumb until the heart- shaped indicator in the PULSE display flashes steadily. Hold your 12E1 thumb at this level. RASE After 5 to 10 seconds, Indicator your pulse will be shown. Hold your thumb on the sensor for another 15 seconds for the most accurate reading.If the displayed pulse ap- pears to be too high or too low, or if your pulse is not displayed, lift your thumb off the sensor and allow the display to reset. Press down again on the sensor as described above. Make sure that your thumb is positioned as shown, and that you are applying the proper amount of pressure to the pulse sensor. Try the sensor several times until you become familiar with it. Remember to stand still while measuring your pulse. 9