Weslo Cadence C22 English Manual - Page 7
Set the Console 1 on the Console Plate 4. - treadmill parts
View all Weslo Cadence C22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
6. Hold the Console (1) near the Console Plate (4). Touch the Handrail (16) to discharge any static. Locate the two wires in the Wire Harness (22) that have L-shaped connectors on the ends. Press the connectors onto the two tabs on the switch shown in inset drawing 6a. Connect the other two wires in the Wire Harness to the back of the Console (1) in the locations shown by the arrows in drawing 6. If the connectors do not fit together easily, rotate them and then connect them. Set the Console (1) on the Console Plate (4). IMPORTANT: Keep the Wire Harness (22) away from the battery access opening and the bosses shown above. Make sure that no wires are pinched before you attach the Console (1) to the Console Plate (4). Finger tighten the five 3/4" Screws (65) into the Console Plate (4) and the Console (1). IMPORTANT: Make sure no wires are damaged by the Screws. After all five Screws have been started, firmly tighten them. 7. Attach a Wheel (15) to each side of the Base (28) with a Wheel Bolt (14) and a Nut (29). 6 Boss Battery Access 16 6a Tabs 7 1 Boss 4 22 65 28 29 15 14 8. Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill. 7