Weslo Cadence Dx5 English Manual - Page 6

3. Without removing the tape from the Latch (38), attach the Latch to the left Upright (37) with four Latch Screws (40). Make sure that the Screws are tight, but do not overtighten them; if the Screws are overtightened, the Latch will not slide smoothly. After the Latch is attached, remove any visible tape. Note: The inset drawing shows how the parts of the Latch (38) fit together. 4. Insert the Wire Harness (53) into the right Upright (37) as you press the Console Base (45) onto (loth Uprights. Insert two Handrail Bolts (82) through each side of the Console Base and through the Uprights as shown. The Handrail Bolts must be Inserted from the inside as shown. Tighten a Handrail Nut (77) with a Handrail Washer (41) onto each Handrail Bolt. 3 37 38 . 40 -- . Spacer 0 , Springs 4 41 77 Bracket Latch r - O 82 45 T...- 77 82 37 • 41 r 53 Tighten all four Handrail Bolts (82) as tightly as possible. Carefully lift up and push down onthe handralls to make sure that the Console Base(45) does not move. Regularly inspect and tight- en all four Handrail Bolts. Handrails 45 , ..,... ■ of 85 85 5. Attach the Frame Guide (66) to the left side of the Frame (21) with two Frame Guide Screws (44) as 5 shown. Note: Be careful not to overtighten the Screws. Make sure that the thick end of the Frame Guide is at the bottom. • - 44 - 66 21 ... Thick end 6. The Console (49) requires two "AA" batteries (not included); alkaline batteries are recommended. 6 Open the Battery Cover (48) as shown. Press two batteries into the battery compartment, with the negative (-) ends of the batteries touching the springs. Close the Battery Cover. 7. Make sure that all parts are properly tightened before you •uselhe-treadmill. The zse of the remaining parts will be described in other sections of this manual. To protect the floor or carpet from damage, place a mat under the treadmill. 6 49 48 . - Batteries----._o I 0