Weslo Pursuit 622 English Manual - Page 7

4. The Console (7) requires two "AA" batteries (not included). Alkaline batteries are recommended. Refer to the inset drawing. Open the battery cover on the underside of the Console and press two batteries into the Console. Make sure that the negative ends of the batteries (marked "-") are touching the springs in the Console. Connect the wire on the Console (7) to the Reed Switch Wire (50). Insert all excess wire into the Handlebar Post (14). Attach the Console to the Handlebar Post with four M4 x 16mm Screws (9). Be careful not to pinch the wire. 5. Press the Side Shield Cover (24) onto the Side Shields (1, 2). Make sure that all four tabs on the Side Shield Cover snap into the Side Shields. Insert the Seat Post (20) into the Frame (15) and press the Seat Post Bushing (23) down into the Frame. Align one of the holes in the Seat Post with the hole in the Frame. Insert the Seat Knob (29) into the Frame and the Seat Post, and tighten the Seat Knob into the Frame. CAUTION: Make sure to insert the Seat Knob through one of the holes in the Seat Post; do not insert the Seat Knob under the Seat Post. Attach the Seat (19) to the Seat Post (20) with three M8 Nylon Locknuts (21) and three M8 Split Washers (49). Note: The Nylon Locknuts and Split Washers may be pre-attached to the bottom of the Seat. 6. Identify the Left Pedal (28); there is an "L" on the Left Pedal for identification. Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the left arm of the Crank (33). Firmly tighten the Right Pedal (not shown) clockwise into the right arm of the Crank (33). Tighten both Pedals as fully as possible. Important: After using the exercise cycle for one week, retighten the Pedals. For the best performance, the Pedals must be kept properly tightened. 4 7 50 9 7 9 14 5 24 19 Tabs 1 2 49 21 23 Batteries Battery Cover 49 21 20 29 15 6 28 33 7. Make sure that all parts are properly tightened before you use the exercise cycle. Note: There may be some hardware left over after assembly is completed. Cover the floor beneath the exercise cycle to protect the floor or carpet from damage. 7