Weslo Pursuit 720s English Manual - Page 11

HOW TO SELECT KILOMETERS AND MILES The console can display distance and speed in either kilometers or miles. The letters ÒKPHÓ or ÒMPHÓ will appear in the upper LCD display to show which unit of measurement is selected. To change the unit of measurement, first look underneath the console and locate the square hole. Look inside the square Square Hole hole and locate the small switch on the printed circuit board. Move the switch to the opposite side to change the unit of measurement. Printed Circuit Board + - Switch SW2 After changing the unit of measurement, remove one of the batteries from the console for about five seconds and then reinsert it. This will reset the console. MAINTENANCE AND STORAGE Tighten all parts of the exercise cycle regularly. The exercise cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away and keep the console out of direct sunlight. CRANK ADJUSTMENT If the arms of the Crank (8) become loose, they should be tightened in order to prevent excessive wear. Slotted Crank Nut Loosen the Hex Crank Nuts (14) 14 on the left arm of 8 the Crank. Place the tip of a stan- dard screwdriver in one of the slots in the slotted crank nut. Tap the screwdriver with a hammer to turn the slotted crank nut counterclockwise until the arms are no longer loose. Do not overtighten the slotted crank nut. When the slotted crank nut is properly tightened, tighten the Hex Crank Nuts. HOW TO ADJUST THE REED SWITCH If the console does not display correct 13 39 8 20 feedback, the reed switch may need to be adjusted. 13 To adjust the 13 reed switch, you must first remove the Left Side 72 Shield (20). Using an adjustable wrench, turn the Left Pedal (39) clockwise and remove it. Next, remove the indicated M4 x 12mm Screws (72) and M4 x 38mm Self-tapping Screws (13). Grasp both Side Shields and gently pull them apart. Turn the left arm of the Crank (8) to the position shown, and then carefully slide the Left Side Shield forward and remove it. 61 42 43 8 View from the Front With the left side shield removed, locate the Reed Switch (42) (see the drawing below). Turn the Crank (8) until the Magnet (61) is aligned with the Reed Switch. Loosen but do not remove the M4 x 16mm Screw (43). Slide the Reed Switch slightly closer to or away from the Magnet. Retighten the Screw. Turn the Crank for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left side shield and the left pedal. BATTERY REPLACEMENT If the console does not function properly, the batteries should be replaced. See assembly step 3 on page 6. 11