Weslo Pursuit E21 English Manual - Page 7

5. Connect the Reed Switch Wire (42) to the corresponding console wire. Attach the ground wire to the Upright (3) with an M4 x 8mm Screw (22). Connect the Pulse Wires (69) to the corresponding console wires. Insert the excess wire into the Upright. Attach the Console (33) to the Upright (3) with four M4 x 16mm Screws (43). Be careful not to pinch the wires or the cable. Press the Resistance Knob (32) onto the Resistance Control (31). Make sure that the mark on the Resistance Knob is correctly aligned. 6. Attach the Seat Upright (64) to the Seat Frame (2) with four M8 x 54mm Carriage Bolts (11), four M8 Flat Washers (51), and four M8 Nylon Locknuts (55). Note: It may be helpful to tip the exercise cycle on its side to attach the Seat Upright. 5 Console 33 Wire Ground Wire 22 32 43 42 Console Wires 69 Be careful not to 31 pinch the wires 3 43 or the cable. 6 11 64 11 7. Attach the Stabilizer (30) to the Seat Frame (2) with 7 two M10 x 70mm Carriage Bolts (27) and two M10 Nylon Locknuts (26). 8. Attach the Seat Bracket (63) to the Seat Upright 8 (64) with four M8 x 66mm Carriage Bolts (52), four M8 Flat Washers (51), and four M8 Nylon Locknuts (55). 7 2 51 55 51 55 2 26 26 30 27 63 52 64 51 55 51