Weslo Summit St100 English Manual - Page 7
E1BEI
View all Weslo Summit St100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
CONSOLE OPERATION The console features a five-mode electronic monitor to provide you with continuous feedback as you exercise. Please read these instructions before operating the monitor. DESCRIPTION OF THE MODES SPEED-Displays your current speed, in steps per minute. TIME-Displays the elapsed time. Note: If you stop exercising for ten seconds or longer, the TIME mode will pause until you resume. DISTANCE-Displays the total number of steps you have completed. CALORIES-Displays the total number of nutritional Calories you have burned. Note: The number displayed is an averaged figure. The actual number may vary depending on the stepping resistance. SCAN-Displays all of the above modes, for five seconds each, in a repeating cycle. MONITOR DIAGRAM A. LCD display. B. Mode indicators-Show which mode is currently selected. C. Mode button-Selects modes. D. On/off button-Turns the power on and off. CIE1BEII SPEED I TIME DISTANCE CALORIES SCAN MODE ON/OFF I i C D BATTERY INSTALLATION The console requires two "AA" batteries (not included) for operation; alkaline batteries are recommended. The battery compartment is located on top of the console near the right side. Slide the battery cover open and remove the battery clip from the console. Find the markings inside the battery clip showing which direction the batteries must be turned. Press the batteries into the battery clip. Replace the battery clip in the console and close the battery cover. Battery Clip Battery 1=3 6==. 4== Cover OPERATING THE MONITOR 1. If there is a piece of clear plastic film on the LCD display, remove it before operating the monitor. To turn the power on, press the on/off button or simply begin stepping. The entire display will appear for two seconds. The monitor will then be ready for operation. 7