Western Digital WD7500H1Q-00 User Manual - Page 32
Connect the interface cable. The WD Drive Manager Status displays see WD
View all Western Digital WD7500H1Q-00 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
MY BOOK STUDIO EDITION II USER MANUAL 6. Replace the cover plate and secure it with the thumbscrew. Note: Do not overtighten the thumbscrew. 7. Close the cover and firmly push down until it locks into place. 8. Reconnect only the power cable to the device. Do not connect computer interface cables. 9. The drive starts the rebuild process automatically and the LEDs cycle from bottom to top. The RAID rebuild may take up to 12 hours depending on drive capacity and activity, but typically will complete in 5-7 hours. Allow the RAID rebuild to complete. Important: Do not attempt to use the device during the rebuild process. 10. Once complete, the LEDs will glow steadily to indicate power-on state. 11. Connect the interface cable. The WD Drive Manager Status displays (see "WD Drive Manager Status" on page 16). 12. Return the replacement drive following the instructions provided in the WD knowledge base article# 1709. Important: Do not disassemble the internal drive and attached assembly components. Return the entire internal drive assembly intact to WD. REPLACING A DRIVE - 29