Western Digital WDXF1600JB Quick Install Guide (pdf) - Page 3

3 Setting up the Drive Windows Note: Your WD drive is preformatted as a single FAT32 partition for compatibility with all Windows operating systems. The FAT32 file system has a maximum file transfer of 4 GB. For more information about file formats and overcoming file size limitations, refer to your operating system manual or visit support.wdc.com, click Knowledge Base, and search for answer ID 1053 for Windows 2000 or answer ID 1021 for Windows XP. Windows 98SE 1. Go to support.wdc.com, click Downloads, locate your product name, and download the device driver installer onto your computer desktop. 2. Double-click the device driver icon to begin installation. 3. When driver installation is completed, restart your computer. 4. After restarting, follow the instructions in Section 2 to connect the drive. Windows automatically detects the drive and a new hard drive icon appears in the My Computer window. Your WD drive is preformatted as a single FAT32 partition and is ready to use. Windows Me/2000/XP 1. After connecting the drive, Windows automatically detects your WD drive and installs the drivers. 2. If prompted, restart your computer. A new drive icon appears in the My Computer window. Your WD drive is preformatted as a single FAT32 partition and is ready to use. Macintosh Important: You must reinitialize or format your WD drive using Apple's Disk Utility before using the drive. Mac OS 9.2.2 1. To format the drive, select Control Panels > Extensions Manager from the Apple menu. 2. Disable File Exchange from the extensions list by clearing the adjacent check box. Click Restart. 3. After restarting, a message appears prompting you to initialize the drive. Enter a name, select Mac OS Extended, and click Initialize. 4. Click Continue to confirm drive initialization. A hard drive icon with the name you assigned appears on the desktop after formatting is completed. To re-enable File Exchange, select the check box in Extensions Manager and click Restart. Your new WD drive is ready to use. Mac OS X 10.1.5 or Later 1. To format the drive, select Applications > Utilities > Disk Utility. Select your new drive on the left panel, and click the Erase tab on the right panel. If prompted, click OK. 2. Select Mac OS Extended from the Volume Format menu, and enter a name for your drive. 3. Click Erase to begin drive formatting. A hard drive icon with the name you assigned appears on the desktop after formatting is completed. To partition the drive into multiple volumes, select the Partition tab from the Disk Utility program menu and follow the instructions. If prompted, restart the system. A new hard drive icon appears on the desktop and your WD drive is ready to use. 4 Disconnecting the Drive CAUTION: To prevent data loss, be sure to close all active applications before shutting down the drive. Windows 1. Double-click the Safely Remove Hardware icon in your system tray (typically located on the bottom right corner of your desktop). 2. Select USB Mass Storage Device from the list and click Stop (Figure 5). Click OK to confirm your selection of the drive to be disconnected. 3. Click Close and press the Power button once. Now you may safely disconnect the USB cable from your computer and the power cord from the electrical outlet. Safely Remove Hardware Icon Macintosh 1. Find the Removable Disk icon associated with the drive you want to disconnect and drag it to the Trash icon on your desktop. 2. After the disk icon disappears from the desktop, you may safely disconnect the USB cable from your computer and the power cord from the electrical outlet. Figure 5 - 3 -