Westinghouse MT25 ARM9 Installation Instructions - Page 2
Warning - wall mount
View all Westinghouse MT25 ARM9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Remove knob from tilt/adapter plate. TILT/ADAPTER PLATE KNOB For Wood Stud Walls: Use a stud finder to locate center of stud. Drill two 3/16" (5 mm) dia. holes to a minimum depth of 2" (51 mm). Attach swing arm to center of wood stud using two screws (D). IMPORTANT: Make sure wall bracket is level on wall. WARNING • Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power. • Never tighten in excess of 80 in • lb (9 N.M.). • Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is highly recommended. WALL BRACKET D WOOD STUD WALL 2 of 6 Visit the Westinghouse Web Site at www.westinghousedigital.com ISSUED: 04-16-04 SHEET #: 095-9194-1 For customer service call 1-866-287-5555.