Westinghouse PT-19H140S User Guide - Page 23
Hdtv/accessory Setup
UPC - 882777054901
View all Westinghouse PT-19H140S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
HDTV/ACCESSORY SETUP Now that you're familiar with the basics of digital television and the various controls and connections for your HDTV, you're ready to enjoy its superb picture quality and sound, along with the ultimate convenience of connecting your game consoles, VCR, DVD, audio devices or personal computer. NOTE: If you have already performed the steps in the Quick Setup Menu, skip to the instructions specific to the accessory you want to connect. Connecting Your HDTV Power • Connect the supplied AC power cord to your HDTV's "AC In" jack and to a properly grounded AC outlet - If you're using an antenna or your cable service, connect the antenna or cable (not supplied) to the "Antenna'" connector first - If you're using a satellite receiver, connect to either the "HDMI" or "Composite" connector (see page 17 for connector descriptions and locations) Press the Power button on either the remote control or the side-mounted control panel to turn your HDTV on (it will take a few seconds to power up) Determining Available Channels • When connected to an antenna or cable source for the first time, you'll need to run "Autoscan"-it shall be available first time when you power on your TV Or Choose Your TV Source • Press the "Menu" button on your remote or the side panel to access the On Screen Display (OSD) - Use the right/left arrow buttons to scroll across to the "Setup" menu - Use the up/down arrow keys to select "TV" and "Quick Setup" • Use the arrow keys to select your "Time Zone", which allows you to receive proper HDTV programming information • Continue with arrow keys to select your signal source "Air/Cable/IRC/HRC" - If you use a rooftop or indoor antenna, select "Air" - If you use a cable service, select "Cable," "IRC" or "HRC" (depending on the frequency used by your cable service) - Press the left arrow key to start scanning for channels NOTE: Once the above process is completed, please exit OSD, press TV button to switch to regular TV input and repeat the above TV Quick Setup again for this input source. 23