Whirlpool ED2VHEXVB Use and Care Guide - Page 5

6= The ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the 1/4"(6.35 mm) water line at either tube connection. Obtain a water strainer from your nearest appliance dealer. Style 2 1. Unplug refrigerator or disconnect power. 2. Remove and discard the shipping tape and the black nylon plug from the gray, coiled water tubing on the rear of the refrigerator. 3. If the gray water tube supplied with the refrigerator is not long enough, a 1/4"x 1/4"(6.35 mm x 6.35 mm) coupling is needed in order to connect the water tubing to an existing household water line. Thread the provided nut onto the coupling on the end of the copper tubing. NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten. AB C D E FG A. Refrigerator water tubing B. Nut (provided) C. Bulb E. Ferrule (purchased) F. Nut (purchased) G. Household water line D. Coupling (purchased) 4= Turn shutoff valve ON. 5. Check for leaks. Tighten any nuts or connections connections at the valve) that leak. (including Style 3 1. Unplug refrigerator or disconnect power. 2. Remove and discard the shipping tape and the black nylon plug from the gray, coiled water tubing on the rear of the refrigerator. 3. Thread the provided nut onto the water valve as shown. NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten. A I/ll B A. Bulb B. Nut (provided) 4= Turn shutoff valve ON. 5. Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak. Complete the Installation Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. 2. Flush the water system. See the "Water and Ice Dispensers" section. NOTE: Allow 24 hours to produce the first batch of ice. Allow 3 days to completely fill ice container. REFRIGERATOURSE 't _/4, For your convenience, your refrigerator controls are preset at the factory. When you first install your refrigerator, make sure that the controls are still preset. The Refrigerator Control and the Freezer Control should both be set to the "mid-settings." Rotary Controls FREEZER REFRIGERATOR z• 4 o COLD r_s COLDER COLD 1 2_ s COLDER Slide Controls Freezer Refrigerator cold I 2 _, 3 4 colder off I 2 A 3 4 colder IMPORTANT: • Your product will not cool when the REFRIGERATOR Control is set to OFR • The Refrigerator Control adjusts the refrigerator compartment temperature. The Freezer Control adjusts the freezer compartment temperature. Settings to the left of the midsetting make the temperature less cold. Settings to the right of the mid-setting make the temperature colder. • Wait 24 hours before you put food into the refrigerator. If you add food before the refrigerator has cooled completely, your food may spoil. NOTE: Adjusting the Refrigerator and Freezer Controls to a higher (colder) than recommended setting will not cool the compartments any faster.