Whirlpool G9IXEFMWS Owners Manual - Page 13

Water is leaking from the dispenser system NOTE: One or two drops of water after dispensing is normal. ■ Glass not being held under the dispenser long enough? Hold the glass under the dispenser 2 to 3 seconds after releasing the dispenser lever. ■ New installation? Flush the water system. See "Water Dispenser." ■ Recently changed water filter? Flush the water system. See "Water Dispenser." ■ Water on the floor near the base grille? Make sure the water dispenser tube connections are fully tightened. See "Refrigerator Doors." Water from the dispenser is warm NOTE: Water from the dispenser is only chilled to 50°F (10°C). ■ New installation? Allow 24 hours after installation for the water supply to cool completely. ■ Recently dispensed large amount of water? Allow 24 hours for water supply to cool completely. ■ Water not been recently dispensed? The first glass of water may not be cool. Discard the first glass of water. ■ Refrigerator connected to a cold water pipe? Make sure the refrigerator is connected to a cold water pipe. See "Water Supply Requirements." ACCESSORIES To order stainless steel cleaner or replacement filters, call 1-800-442-9991 and ask for the part number listed below or contact your authorized Whirlpool dealer. In Canada, call 1-800-807-6777. Stainless Steel Cleaner and Polish: Order Part #4396095 In Canada, Order Part #31462B Replacement Filter: Order Part #4396701 (L200V / NL120V / NLC120V) WATER FILTER CERTIFICATIONS 13