Whirlpool GBS277PDB Installation Instructions - Page 3

Electrical Requirements, Microwave Oven Preparation, Bottom Duct Assembly, Side Duct and Upper Duct - appliances

Get Whirlpool GBS277PDB PDF manuals and user guides View all Whirlpool GBS277PDB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

Electrical Requirements WARNING Bottom Duct Assembly 1. Position supports over tabs of bottom duct floor, making sure all 3 tabs are inside each support. Align the tab holes with the screw holes on the sides of the supports. Fasten supports to bottom duct floor with six ¹⁄₂" screws, as shown. A Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Observe all governing codes and ordinances. A 120-Volt, 60-Hz, AC-only, 15- or 20-amp fused electrical supply (or circuit breaker) is required. (A time-delay fuse or circuit breaker is recommended.) It is recommended that a separate circuit serving only this appliance be provided. GROUNDING INSTRUCTIONS s For all cord connected appliances: The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded. Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. SAVE THESE INSTRUCTIONS Microwave Oven Preparation 1. Unplug microwave oven before proceeding with installation. 2. Remove any loose items inside microwave oven. A. ¹⁄₂" screws 2. Fasten bottom bracket to bottom duct using two ¹⁄₂" screws. (Rear view of bottom duct) A B A. Bottom bracket B. ¹⁄₂" screws 3. Install bottom duct with two ¹⁄₂" screws. (Front view of microwave oven) A A. ¹⁄₂" screws Side Duct and Upper Duct Assembly 1. Remove existing screw from left side of microwave oven. 2. Connect side duct to upper duct: Insert projecting tabs of upper duct into holes of side duct. Then bend tabs upward. A B A. Tabs of upper duct B. Holes in side duct 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
3
Electrical Requirements
Observe all governing codes and ordinances. A 120-Volt, 60-Hz,
AC-only, 15- or 20-amp fused electrical supply (or circuit breaker)
is required. (A time-delay fuse or circuit breaker is
recommended.) It is recommended that a separate circuit serving
only this appliance be provided.
Microwave Oven Preparation
1.
Unplug microwave oven before proceeding with installation.
2.
Remove any loose items inside microwave oven.
Bottom Duct Assembly
1.
Position supports over tabs of bottom duct floor, making sure
all 3 tabs are inside each support. Align the tab holes with the
screw holes on the sides of the supports. Fasten supports to
bottom duct floor with six
¹⁄₂
" screws, as shown.
2.
Fasten bottom bracket to bottom duct using two
¹⁄₂
" screws.
(Rear view of bottom duct)
3.
Install bottom duct with two
¹⁄₂
" screws.
(Front view of microwave oven)
Side Duct and Upper Duct Assembly
1.
Remove existing screw from left side of microwave oven.
2.
Connect side duct to upper duct:
Insert projecting tabs of upper duct into holes of side duct.
Then bend tabs upward.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Do not use an extension cord.
Do not use an adapter.
Do not remove ground prong.
GROUNDING INSTRUCTIONS
■
For all cord connected appliances:
The microwave oven must be grounded. In the event
of an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire for
the electric current. The microwave oven is equipped
with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the
grounding
instructions
are not completely understood
, or if doubt exists as to
whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord
is too short, have a qualified electrician or serviceman
install an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
A.
¹⁄₂
" screws
A. Bottom bracket
B.
¹⁄₂
" screws
A.
¹⁄₂
" screws
A. Tabs of upper duct
B. Holes in side duct
A
A
B
A
A
B