Whirlpool GEW9250SU Use and Care Guide - Page 25
Troubleshooting - dryer troubleshooting
View all Whirlpool GEW9250SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
TROUBLESHOOTING First try the solutions suggested here and possibly avoid the cost of a service call... Dryer Operation Dryer will not run s Has a household fuse blown, or has a circuit breaker tripped? There may be 2 household fuses or circuit breakers for the dryer. Check that both fuses are intact and tight, or that both circuit breakers have not tripped. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. s Is the correct power supply available? Electric dryers require 240-volt power supply. Check with a qualified electrician. s Was a regular fuse used? Use a time-delay fuse. s Is the dryer door firmly closed? s Was the Start button firmly pressed? Large loads may require pressing and holding the Start button for 2-5 seconds. No heat s Has a household fuse blown, or has a circuit breaker tripped? The drum may be turning, but you may not have heat. Electric dryers use 2 household fuses or circuit breakers. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. Unusual sounds s Has the dryer had a period of non-use? If the dryer hasn't been used for a while, there may be a thumping sound during the first few minutes of operation. s Is a coin, button, or paper clip caught between the drum and front or rear of the dryer? Check the front and rear edges of the drum for small objects. Clean out pockets before laundering. s Are the four legs installed, and is the dryer level front to back and side to side? The dryer may vibrate if not properly installed. See the Installation Instructions. s Is the clothing knotted or balled up? When balled up, the load will bounce, causing the dryer to vibrate. Separate the load items and restart the dryer. Dryer Results Clothes are not drying satisfactorily, drying times are too long, or load is too hot s Is the lint screen clogged with lint? Lint screen should be cleaned before each load. WARNING Fire Hazard Use a heavy metal vent. Do not use a plastic vent. Do not use a metal foil vent. Failure to follow these instructions can result in death or fire. s Is the exhaust vent or outside exhaust hood clogged with lint, restricting air movement? Run the dryer for 5-10 minutes. Hold your hand under the outside exhaust hood to check air movement. If you do not feel air movement, clean exhaust system of lint or replace exhaust vent with heavy metal or flexible metal vent. See the Installation Instructions. s Are fabric softener sheets blocking the grille? Use only one fabric softener sheet, and use it only once. s Is the exhaust vent the correct length? Check that the exhaust vent is not too long or has too many turns. Long venting will increase drying times. See the Installation Instructions. s Is the exhaust vent diameter the correct size? Use 4" (10.2 cm) diameter vent material. Dryer displaying code message s "PF" (power failure), check the following: Was the drying cycle interrupted by a power failure? Press and hold START to restart the dryer. s "E" Variable (E1, E2, E3) service codes: Call for service. 25