Whirlpool GJC3055RS Installation Instructions - Page 8

3-Wire Cable from Power Supply to 3-Wire Cable from Cooktop IMPORTANT: Use the 3-wire cable from power supply where local codes permit connecting the frame-ground conductor to the neutral (white) junction box wire: Attach Cooktop to Countertop NOTE: This section applies only if you are using clamp brackets. A D D A E F B E C G B H C A. Red wires B. Bare or green wire from cooktop C. 3-wire cable (from cooktop) D. Junction box E. White wire (from power supply) F. UL listed wire nut G. Black wire H. UL listed or CSA approved conduit connector A. Glass cooktop B. Burner box C. Clamp bracket F D. Countertop E. 2½" (6.4 cm) clamping screw F. Attachment screw 1. Place the 2½" (6.4 cm) clamping screws into the brackets. 2. Check to be sure the cooktop is still level. 3. Use a flat-blade screwdriver to tighten the screws against the countertop. Do not overtighten. 1. Disconnect power 2. Remove junction box cover, if present. 3. Connect the flexible cable conduit from the cooktop to the junction box using a UL listed or CSA approved conduit connector. 4. Tighten screws on conduit connector if present. 5. Connect the two black wires together using the UL listed wire nuts. 6. Connect the two red wires together using the UL listed wire nuts. 7. Connect the green or bare cooktop cable wires to the white (neutral) wire in the junction box using the UL listed wire nuts. 8. Install junction box cover. 9. Reconnect power. Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Dispose of/recycle all packaging materials. 3. Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by protective shipping material. Dry thoroughly with a soft cloth. For more information, see the "Cooktop Care" section of the Use and Care Guide. 4. Read "Cooktop Use" in the cooktop Use and Care Guide. NOTE: If the cooktop does not work after turning on the power, check that a circuit breaker has not tripped or a house fuse has not blown. See "Troubleshooting" section in the Use and Care Guide for further information. If you need Assistance or Service: Please reference the "Assistance or Service" section of the Use and Care Guide or contact the dealer from whom you purchased your cooktop. 8