Whirlpool GU2800XTVQ Owners Manual - Page 6

OPTION SELECTIONS OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH: Loads containing tough, baked-on food. Increases the target water temperature during the wash portions of the cycle. Adds heat, wash time and water to the cycle. Adaptive Wash, Pots & Pans or Normal cycle To sanitize your dishes and glassware in accordance with NSF/ANSI Standard 184 for Residential Dishwashers. For best drying results, dry dishes with heat. Raises the water temperature in the final rinse to approximately 155°F (68°C). This high temperature rinse sanitizes your dishes and glassware in accordance with NSF/ANSI Standard 184 for Residential Dishwashers. Certified residential dishwashers are not intended for licensed food establishments. The Sanitize or Sani Rinse option adds heat and time to the cycle. Turn OFF when loads contain plastic dinnerware that may be sensitive to high temperatures. This option with the use of rinse aid will provide the best drying performance. Adaptive Wash, Pots & Pans or Normal cycle. Only these sanitization cycles have been designed to meet the NSF/ANSI requirements. Available with any cycle except Rinse Only. To run your dish washer at a later time or during offpeak hours. Delays the start of a cycle up to 6 hours. Select a wash cycle and options. Press Delay until reaching the desired hours for the delay to start. Press START/RESUME. Close the door firmly. All cycles, except Rinse Only Control Lock To avoid unintended use of your dishwasher, or cycle and option changes during a cycle. To turn on Lock, press and hold Heated Dry for at least 4 seconds. To turn off Lock, press and hold Heated Dry for at least 4 seconds. When Control Lock is lit, all buttons are disabled. If you press any pad while your dishwasher is locked, the light flashes 3 times. The dishwasher door can be opened while the controls are locked. Anytime CONTROLS AND CYCLE STATUS CONTROL PURPOSE To start or resume a wash cycle COMMENTS If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator flashes. The cycle will not resume until the door is closed and Start/Resume is pressed. To cancel wash cycle Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher drain completely. To follow the progress of your dishwasher cycle To follow the progress of your dishwasher cycle To follow the progress of your dishwasher cycle The Washing indicator glows at the start of the first fill of any cycle (except Rinse Only) and remains on until the end of the main wash cycle. The Drying indicator glows during the drying portion of each cycle (except Speed Wash and Rinse Only). Clean indicator glows when a cycle is finished. To follow the progress of your dishwasher cycle If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the "Sanitized" indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle. This can happen if the cycle is interrupted, or the water could not be heated to the required temperature. The light goes off when you open and close the door or press CANCEL. 6