Whirlpool GU3200XTXB Installation Guide - Page 18
Connect to Drain
View all Whirlpool GU3200XTXB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Place paper towel under 90° elbow fitting. Turn on water supply and check for leaks. If leak occurs, repeat previous step. If needed, see website for animated representation of this step. Visit www.whirlpool.com/watersupply under FAQ tab. NOTE: Do not use Teflon®† tape with compression fittings. Connect to Drain Place towel under drain hose to catch any water in drain hose. Place the small green drain hose clamp onto the small end of the drain hose. Push the new drain hose into the black drain hose connector up to the drain hose stop. Using pliers, squeeze open the small green drain hose clamp and slide onto connector between stops. NOTES: ■ To help minimize vibration, route drain hose to avoid contact with motor, door springs, water line, cabinet, flooring or the edge of the hole when it passes through the cabinet. ■ Do not remove drain loop from side of dishwasher. ■ Place pan under end of drain hose. Pan will collect any water in drain hose. After hose is connected, remove towel. If needed, see website for animated representation of this step. Visit www.whirlpool.com/drain under FAQ tab. †®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company. 18