Whirlpool RBS305PVQ Dimension Guide - Page 4

Approved Built-In Oven and Gas Cooktop Combinations A B C D E D E F G H I J M L K N A. 24" (61 cm) cabinet depth B. 1" (2.5 cm) clearance to bottom of countertop C. 25" (63.5 cm) countertop depth D. Recommended oven junction box locations E. 1" (2.5 cm) clearance to cabinet F. 27¾" (70.5 cm) minimum cutout height G. Allow 1.6 cm) for oven trim to overlap on each side. H. 36" (91.4 cm) from cabinet base to countertop I. Gas line through wall 10¹⁄₂" (26.7 cm) to center of cutout J. 3¼" (8.3 cm) K. Gas line through floor 10½" (26.7 cm) to center of cutout L. 3½" (8.9 cm) M. 4⁵⁄₈" (11.7 cm) from floor N. See Cutout Dimensions chart. CUTOUT DIMENSIONS Oven Size 24" (61 cm) 27" (68.6 cm) 30" (76.2 cm) 36" (91.4 cm) Oven Cutout Dimension 22¹⁄₂" (57.2 cm) 25¹⁄₂" (64.8 cm) 28½" (72.4 cm) 34¹⁄₂" (87.6 cm) For the approved model number combination refer to the undercounter label located on top of the oven chassis. NOTE: For undercounter installation, it is recommended that the junction box for oven be located in the adjacent right or left cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the upper rear right or left corner of the side wall surface to pass the appliance cable through to the junction box. On models with Steam-Assist, it will be necessary to drill a ½" (1.3 cm) minimum diameter hole in the upper right or left rear corner of the side wall to pass the water supply tubing through to the undersink water filter. If water supply tubing hole is drilled on the same side as the oven cable hole, a minimum of 2" (5.1 cm) is required between the 2 holes. The upper shaded areas are recommended locations for recessed junction box for 120-volt grounded outlet for cooktop. Lower shaded areas are recommended locations for flexible or rigid gas pipe installation. The gas pipe can be installed on either side of the cutout, and either through the floor or through the wall. 3