Whirlpool SF362LXTT Installation Instructions
Whirlpool SF362LXTT - 30"GAS S/C ACCUBAKE CUST BROIL Manual
 |
UPC - 883049054957
View all Whirlpool SF362LXTT manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool SF362LXTT manual content summary:
- Whirlpool SF362LXTT | Installation Instructions - Page 1
2 Tools and Parts 2 Location Requirements 3 Electrical Requirements 4 Gas Supply Requirements 5 INSTALLATION INSTRUCTIONS 6 Unpack Range 6 Install Anti-Tip Bracket 6 Verify Anti-Tip Bracket Location 7 Level Range 7 Make Gas Connection 7 Electronic Ignition System 8 Replace Oven Racks and - Whirlpool SF362LXTT | Installation Instructions - Page 2
service must be performed by a qualified installer, service agency or the gas supplier. In the State of Massachusetts, the following installation instructions apply: s Installations and repairs hardware store. Parts needed Check local codes and consult gas supplier. Check existing gas supply and - Whirlpool SF362LXTT | Installation Instructions - Page 3
's responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located on the oven frame behind the storage drawer panel. Product Dimensions Freestanding Range s The range should be located for convenient use in the kitchen - Whirlpool SF362LXTT | Installation Instructions - Page 4
range, follow the instructions for dimensional clearances above the cooktop surface. IMPORTANT: Some cabinet and building materials are not designed to withstand the heat produced by the oven for baking and self-cleaning. Check adequate. A copy of the above code standards can be obtained from: - Whirlpool SF362LXTT | Installation Instructions - Page 5
. If the types of gas listed do not include the type of gas available, check with the local gas supplier. LP gas conversion: Conversion must be done by a qualified service technician. No attempt shall be made to convert the appliance from the gas specified on the model/serial rating plate for use - Whirlpool SF362LXTT | Installation Instructions - Page 6
" WCP) or lower The range must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of that system at test pressures equal to or less than ½ psi (3.5 kPa). INSTALLATION INSTRUCTIONS Unpack Range WARNING Excessive Weight Hazard Use - Whirlpool SF362LXTT | Installation Instructions - Page 7
in drawer guides. Remove drawer and set it aside on a protected surface. See the Use and Care Guide for the model drawer range is level. Push range back into position. Check that rear leveling leg is engaged in anti-tip bracket. NOTE: Oven must be level for satisfactory baking performance. Make Gas - Whirlpool SF362LXTT | Installation Instructions - Page 8
not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 5. Plug into a grounded 3 prong outlet. Electronic Ignition System Initial lighting and gas flame adjustments Cooktop and oven burners use electronic igniters in place of standing pilots - Whirlpool SF362LXTT | Installation Instructions - Page 9
to light the bake and broil burners. Refer to the Use and Care Guide for proper operation of the oven controls. Adjust Oven Bake Burner Flame (if needed) 1. On models with a warming drawer, remove access cover plate (1 screw) located at the back of the warming drawer compartment. 2. Check the oven - Whirlpool SF362LXTT | Installation Instructions - Page 10
and Care Guide for specific instruction on range operation. If range does not operate, check the following: s Household fuse is intact and tight; or circuit breaker has not tripped. s Range is plugged into a grounded 3 prong outlet. s Electrical supply is connected. s See "Troubleshooting" in the - Whirlpool SF362LXTT | Installation Instructions - Page 11
. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. To Convert Gas Pressure Regulator 1. Turn the manual shutoff valve to the closed position. Unplug - Whirlpool SF362LXTT | Installation Instructions - Page 12
LP gas orifice spud. LP Gas Orifice Spud Chart for Standard Surface Burners Burner Rating Color Size ID Number 12,000 BTU 11,000 BTU 8,000 BTU 5,000 BTU Green/Magenta Green/Yellow Green/Lt. Blue Green/Brown 1.03 mm 0.99 mm 0.80 mm 0.65 mm L103 L99 L80 L65 NOTE: Refer to the Model Number - Whirlpool SF362LXTT | Installation Instructions - Page 13
" in the "Installation Instructions" section of this manual to complete this procedure. Convert from LP Gas to Natural Gas WARNING To Convert Gas Pressure Regulator 1. Turn the manual shutoff valve to the closed position. Unplug range or disconnect power. B A C A. To range B. Manual shutoff valve - Whirlpool SF362LXTT | Installation Instructions - Page 14
have to adjust the "LO" setting for each cooktop burner. Checking for proper cooktop, bake and broil burner flame is very important. Natural gas flames do not have yellow tips. 3. Refer to "Complete Installation" in the "Installation Instructions" section of this manual to complete this procedure. - Whirlpool SF362LXTT | Installation Instructions - Page 15
Notes 15 - Whirlpool SF362LXTT | Installation Instructions - Page 16
ANTI-TIP BRACKET TEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall. Top edge Left edge 9762998 © 2005. All rights reserved. 12/05 Printed in U.S.A.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
INSTALLATION INSTRUCTIONS
30" (76 CM) FREESTANDING GAS RANGES
RANGE SAFETY
Table of Contents
RANGE SAFETY
..................................................................
1
INSTALLATION REQUIREMENTS
....................................
2
Tools and Parts
................................................................
2
Location Requirements
....................................................
3
Electrical Requirements
...................................................
4
Gas Supply Requirements
...............................................
5
INSTALLATION INSTRUCTIONS
......................................
6
Unpack Range
.................................................................
6
Install Anti-Tip Bracket
.....................................................
6
Verify Anti-Tip Bracket Location
......................................
7
Level Range
.....................................................................
7
Make Gas Connection
.....................................................
7
Electronic Ignition System
...................................................
8
Replace Oven Racks and Storage or Warming Drawer ... 10
Complete Installation
.........................................................
10
GAS CONVERSIONS
............................................................
11
Convert from Natural Gas to LP Gas
................................
11
Replace Oven Racks and Storage or Warming Drawer ... 13
Complete Installation
.........................................................
13
Convert from LP Gas to Natural Gas
................................
13
Replace Oven Racks and Storage or Warming Drawer ... 14
Complete Installation
.........................................................
14
ANTI-TIP BRACKET TEMPLATE
.......................................
16
IMPORTANT:
Installer:
Leave installation instructions with the homeowner.
Homeowner:
Keep installation instructions for future reference.
Save installation instructions for local electrical inspector's use.
9762998
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death or serious burns to children and adults.