Whirlpool UXB1200DYS Installation Guide - Page 4

4. Install the 6 mm nuts to the outside top or outside back Dual Blower Motor Assembly (alternate location on some models) of the range hood at the proper location for the selected motor system. A ■ Two 6 mm nuts are required for the single motor system. Clip nuts into the small square notches located at the left and right end of the square vent opening. ■ Five 6 mm nuts are required for the dual motor system. Clip nuts into the small square notches, one located in the front of the square vent opening and the other four located at the left and right ends of the square vent opening. A A. Wiring connection A 2. Slide the left mounting plate flange under the motor mounting bracket. A B A. Clip nut (6 mm) locations for dual motor assembly (quantity 5) B. Clip nut (6 mm) locations for single motor assembly (quantity 2) 5. Mount range hood using the Installation Instructions that came with your range hood model. Install Range Hood Blower Motor 1. Install the range hood blower motor assembly inside the range hood canopy with the wiring connection to the left for the single motor system and to the front or top for the dual motor system. Single Blower Motor Assembly AB A. Motor mounting bracket B. Mounting plate left flange 3. Run the power supply wires and connector from the range hood through the hole in the right end of the motor mounting plate. A A A. Wiring connection B A. Motor mounting plate hole B. Power supply wires and connector 4