Whirlpool UXT2036AYB Use & Care Guide - Page 8

4. Use saber or keyhole saw to cut the circular vent opening. 3. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown. *5" (12.7 cm) 7 ¹/₄" (18.4 cm) diam. cabinet cutouts A A. Drill pilot hole 4. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot holes. Leave about ¹⁄₄" (6.4 mm) space between screw heads and cabinet to slide range hood into place. *From wall, not cabinet frame Install Vent System 1. Install vent through the vent opening in upper cabinet or wall. Complete venting system according to the selected venting method. See "Venting Requirements" section. 2. Use caulking to seal exterior wall or roof opening around the cap. Install Range Hood NOTE: Your model will have a 7" (17.8 cm) round vent mounting plate on the inside of your range hood. 1. Remove the 7" (17.8 cm) round vent mounting plate attached with 3.5 x 9.5 mm screws on the inside of your range hood. Use these screws to install the round vent mounting plate. A ¹⁄₄" (6.4 mm) 5. Remove top rectangular and round vent knockouts. A B A. Round vent knockout B. Top rectangular vent knockout 6. Install 7" (17.8 cm) round vent mounting plate. Attach to range hood with the 3.5 x 9.5 mm screws provided. NOTE: An optional 7" (17.8 cm) round damper is available as an accessory. For information on ordering, see the "Accessories" section. A B C D B A. 7" (17.8 cm) round vent mounting plate B. 3.5 x 9.5 mm screws 2. Lift the range hood up under cabinet and determine final location by centering beneath cabinet. Mark on the underside of cabinet the location of the 4 keyhole mounting slots on the range hood. Set range hood aside on a covered surface. A A. Keyhole slot E A. 7" (17.8 cm) Round damper (see "Accessories" section) B. 3.5 x 9.5 mm screws C. 7" (17.8 cm) round vent mounting plate D. Round vent knockout E. Rectangular vent knockout NOTE: The 7" (17.8 cm) round vent mounting plate can be installed up to 1" (2.5 cm) on either side of the hood center to accommodate off center ductwork. 8