Whirlpool WCD5090JW Owners Manual - Page 13
Direct Wire Connection
View all Whirlpool WCD5090JW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
6. Connect remaining wires 5. Connect remaining wires Connect remaining wires under outer terminal block screws. Tighten screws. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." 3-Wire Power Supply Connection IMPORTANT: Use where local codes permit connecting cabinetground conductor to neutral wire. Connect remaining wires under outer terminal block screws. Tighten screws. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." Direct Wire Connection Direct wire strain relief 1. Attach direct wire strain relief A. 3-wire receptacle (NEMA type 10-30R) B. 3-wire plug C. Neutral prong D. Spade terminals with upturned ends 3. Remove center screw E. 3/4" (19 mm) UL-listed strain relief F. Ring terminals G. Neutral (white or center wire) Unscrew the removable conduit connector (A) and any screws from a 3/4" (19 mm) UL listed strain relief (UL marking on strain relief). Put the threaded section of the strain relief through the hole below the terminal block opening (B). Reaching inside the terminal block opening, screw the removable conduit connector (A) onto the strain relief threads (C) and tighten securely. 2. Attach direct wire cable to strain relief Remove center terminal block screw (B). 4. Connect neutral wire Connect neutral wire (white or center) (C) of power supply cord under center terminal block screw (B). Tighten screw. Put direct wire cable through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable. For 4-wire Direct Wire Connection, continue to step 3. 4-wire direct wire connection: Go to "4-Wire Direct Wire Connection." For 3-wire Direct Wire Connection, continue to step 3. 3-wire direct wire connection: Go to "3-Wire Direct Wire Connection." 13