Whirlpool WCG55US0HS Instruction Sheet - Page 3
Warning - manual
View all Whirlpool WCG55US0HS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Tools and Parts Gather the required tools and parts necessary for correct LP gas conversion. Tools needed ■ Flat-blade screwdriver 0 [2.0 mm]) flat-blade screwdriver (screwdriver shaft must be a minimum of 2" [5.1 cm] long) ■ Adjustable wrench ■ 7.0 mm nut driver ■ 7.0 mm wrench ■ T10 Torx®† adapter Parts needed For models KCGS550ESS, KCGS556ESS, KCGS950ESS and KCGS956ESS use the following parts: ■ LP orifice package (W10676662) ■ Conversion instructions (W10597146A) For all other models use the following parts: ■ LP orifice package (W10676661) ■ Conversion instructions (W10597146A) High Altitude Conversion To convert the cooktop for elevations above 6,560 ft (1999.5 m), order a High Altitude Conversion Kit. For models KCGS550ESS, KCGS556ESS, KCGS950ESS and KCGS956ESS use the following parts: ■ Part Number W10679116 - LP high altitude ■ Part Number W10679118 - Natural gas high altitude For all other models use the following parts: ■ Part Number W10679114 - LP high altitude ■ Part Number W10679113 - Natural gas high altitude To order, see the "Assistance or Service" section of the User Guide. IMPORTANT: Gas conversions from Natural gas to LP gas must be done by a qualified installer. Before proceeding with conversion, shut off the gas supply to the cooktop prior to disconnecting the electrical power. WARNING This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer's instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion or production of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper and complete until the operation of the converted appliance is checked as specified in the manufacturer's instructions supplied with this kit. WARNING Explosion Hazard Use a new CSA International approved gas supply line. Install a shut-off valve. Securely tighten all gas connections. If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column. Examples of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Failure to do so can result in death, explosion, or fire. Convert from Natural Gas to LP Gas 1. Turn manual shutoff valve to the closed position. B A C A. To cooktop B. Shutoff valve (closed position) C. Gas supply line 2. Unplug cooktop or disconnect power. To Convert Gas Pressure Regulator B A C D A. Access cap B. Rear of cooktop C. Gas pressure regulator D. Gas flow 3. Determine the type of regulator you have: Style 1: The cap has a slot and "NAT" printed on it. Remove access cap by using a flat-blade screwdriver or coin, turning the access cap counterclockwise. †®TORX is a registered trademark of Acument Intellectual Properties, LLC. 3