Whirlpool WDT910SSYW Use & Care Guide - Page 7
Select a Cycle cycles vary by model, Select Options options vary by model, Start or Resume a Cycle,
View all Whirlpool WDT910SSYW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
■ To add rinse aid, turn the dispenser cap to "Refill" and lift off. Pour rinse aid into the opening until the indicator level is at "Full." Replace the dispenser cap and turn to "Lock." Make sure cap is fully locked. RReefiflilll LLoocckk ffililll ------66554 4 ------- - - - m maaxx - 21 3 21 3 - -- ---- STEP 3 Select a Cycle (cycles vary by model) See "Cycle and Option Descriptions" charts in the following section. Heavier cycles and options affect cycle length. ¹⁄₄ turn to lock NOTE: For most water conditions, the factory setting will give good results. ■ Check water hardness level to ensure no rings or spots on your dishware before adding rinse aid or adjusting the factory setting. ■ If you have hard water or notice rings or spots, try a higher setting. Turn the arrow adjuster inside the dispenser by either using your fingers or inserting a flat-blade screwdriver into fill - - - the center of the arrow and turning. Select Options (options vary by model) See "Cycle and Option Descriptions" charts in the following section. You can customize your cycles by pressing the options desired. max - - -- --- - - -- STEP 4 Start or Resume a Cycle ■ Run hot water at the sink nearest your dishwasher until the water is hot. Turn off water. For best dishwashing results, water should be 120ºF (49ºC) as it enters the dishwasher. ■ For models with controls on top of the door, select wash cycle, option and press START/RESUME before closing the door. Push door firmly closed. The door latches automatically. Select the wash cycle, options and press STAR/RESUME or press START/RESUME to repeat the same cycle and options as in the previous wash cycle. ■ You can add an item anytime at the beginning of the cycle. Open the door slowly and add the item. Close the door firmly. Press START/RESUME. 7