Whirlpool WED4985E Installation Instructions - Page 5
Minimum Required Spacing
View all Whirlpool WED4985E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector. Installation clearances: The location must be large enough to allow the dryer door to open fully. Dryer Dimensions 223/4" (578 mm) 273/4"* (705 mm) 26"** (660 mm) 29" (737 mm) Minimum spacing for recessed area or closet installation The dimensions shown following are for the minimum spacing allowed: ■■ Additional spacing should be considered for ease of installation and servicing. ■■ Additional clearances might be required for wall, door, and floor moldings. ■■ Additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer. ■■ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. ■■ Companion appliance spacing should also be considered. Minimum Required Spacing 411/2" (1054 mm) 14" max. (356 mm) 3"/3" (76 mm/76 mm) 133/4" (349 mm) 273/4"* (705 mm) 26"** (660 mm) 11/2" (38 mm) A 29" (737 mm) 411/2" (1054 mm) 51/2"/0" (140 mm/0 mm) 1"/0" (25 mm/0 mm) 18"/18" (457 mm/ 457 mm) 48 in.2/48 in.2 (310 cm2/ 310 cm2) 24 in.2/24 in.2 (155 cm2/ 155 cm2) 1"/1" (25 mm/ 25 mm) 3"/3" (76 mm/76 mm) *Recommended/Minimum spacing 1/2" (13 mm) B A. Wide opening side-swing door B. Wide opening hamper door *6.5 or 7.0 cu. ft. capacity models ** 6.0 cu. ft. capacity models NOTES: ■■ Most installations require a minimum 5½" (140 mm) clearance behind the dryer for the exhaust vent with elbow. See "Venting Requirements." ■■ Leveling legs should be 1/2" (13 mm) (to match height of 3.6 cu. ft. capacity washer) or 1½" (38 mm) (to match height of 3.8 cu. ft. capacity washer). Mobile home - Additional installation requirements This dryer is suitable for mobile home installations. The installation must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). ■■ Metal exhaust system hardware, which is available for purchase from your dealer. ■■ Special provisions must be made in mobile homes to introduce outside air into the dryer. The opening (such as a nearby window) should be at least twice as large as the dryer exhaust opening. 5