Whirlpool WED5010LW Owners Manual - Page 7
Installation Instructions, Requirements, Tools And Parts
View all Whirlpool WED5010LW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
To winterize the dryer: 1. Unplug dryer or disconnect power. 2. Shut off water faucet. 3. Disconnect water inlet hose from faucet and drain. To use the dryer again: 1. Flush water pipes. Reconnect water inlet hose to faucet. Turn on water faucet. 2. Plug in dryer or reconnect power as described in the Installation Instructions. Reinstalling the Dryer Follow the Installation Instructions to locate, level, and connect the dryer. Special Instructions for Steam Models Install and store your dryer where it will not freeze. Because some water may stay in the hose, freezing can damage your dryer. If storing or moving your dryer during freezing weather, winterize it. Water inlet hose Replace inlet hose and hose screen after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hose if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hose, record the date of replacement. INSTALLATION REQUIREMENTS Tools and Parts NOTE: Install the clothes dryer according to the manufacturer's instructions and local codes. Gather required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed for All Installations: Utility knife Tin snips Caulking gun and compound Adjustable wrench that opens to 1" (25 mm) or hex-head socket wrench Additional Tools Needed (on some models): Putty knife Parts Supplied (all models): Flat-blade screwdriver Wire stripper 1/4" Nut driver Level Leveling legs (4) (Length and appearance of legs may vary according to model) Parts package is located in dryer drum. Check that all parts are included. NOTE: Do not use leveling legs supplied with dryer if installing with a pedestal or stack kit. Parts Needed (steam models): "Y" connector Rubber washer Pliers Tape measure 2' (0.6 m) inlet hose 5' (1.52 m) inlet hose 7