Whirlpool WED5510VQ Installation Instructions
Whirlpool WED5510VQ Manual
 |
View all Whirlpool WED5510VQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WED5510VQ manual content summary:
- Whirlpool WED5510VQ | Installation Instructions - Page 1
.7 CM) ELECTRIC DRYER INSTALLATION INSTRUCTIONS INSTRUCTIONS POUR L'INSTALLATION DE LA SÉCHEUSE ÉLECTRIQUE DE 29" (73,7 CM) Table of Contents / Table des matières DRYER SAFETY 1 INSTALLATION INSTRUCTIONS 2 Tools and Parts 2 Location Requirements 2 Electrical Requirements - U.S.A 3 Electrical - Whirlpool WED5510VQ | Installation Instructions - Page 2
proper exhaust installation. See "Venting Requirements." A separate 30-amp circuit. If you are using a power supply cord, a grounded electrical outlet located within 2 ft (610 mm) of either side of the dryer. See "Electrical Requirements." A sturdy floor to support the total weight (dryer and load - Whirlpool WED5510VQ | Installation Instructions - Page 3
opening hamper door *Most installations require a minimum 5" (127 mm) clearance behind the dryer for the exhaust vent with elbow. See "Venting Requirements." Installation spacing for recessed area or closet installation The following spacing dimensions are recommended for this dryer. This dryer has - Whirlpool WED5510VQ | Installation Instructions - Page 4
in a risk of electric shock. Check with a qualified electrician or service representative or personnel if you are in doubt as to whether the dryer is properly grounded. Do not modify the plug on the power supply cord: if it will not fit the outlet, have a proper outlet installed by a qualified - Whirlpool WED5510VQ | Installation Instructions - Page 5
using a replacement power supply cord, it is recommended that you use Power Supply Cord Replacement Part Number 3394208. For further information, please reference the service numbers located in the Dryer User Instructions. GROUNDING INSTRUCTIONS For a grounded, cord-connected dryer: This dryer must - Whirlpool WED5510VQ | Installation Instructions - Page 6
new UL listed 30 amp power supply cord. Use a UL listed strain relief. Disconnect power before making electrical connections. Connect neutral wire ( ground wire F. Hole below terminal block opening 3. Install strain relief. Style 1: Power supply cord strain relief Remove the screws from a 3⁄4" (19 - Whirlpool WED5510VQ | Installation Instructions - Page 7
against the direct wire cable. Electrical Connection Options If your home has: And you will be connecting to: Go to Section 4-wire receptacle (NEMA Type 14-30R) A UL listed, 120/240-volt minimum, 30-amp, dryer power supply cord* 4-wire connection: Power supply cord 4-wire direct 5" (127 mm - Whirlpool WED5510VQ | Installation Instructions - Page 8
of power supply cord F. Neutral ground wire 4. Connect the other wires to outer terminal block screws. Tighten screws. 5. Tighten strain relief screws. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 7. You have completed your electrical - Whirlpool WED5510VQ | Installation Instructions - Page 9
. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 7. You have completed your electrical connections. Now go to "Venting Requirements." 3-wire connection: Power Supply Cord Use where local codes permit connecting cabinet-ground conductor to - Whirlpool WED5510VQ | Installation Instructions - Page 10
B C D Optional 3-wire connection Use for direct wire or power supply cord where local codes do not permit connecting cabinet-ground conductor to block cover into slot of dryer rear panel. Secure cover with hold-down screw. 6. You have completed your electrical connections. Now go to "Venting - Whirlpool WED5510VQ | Installation Instructions - Page 11
or by calling the toll-free number listed on the cover of the Dryer User Instructions. For more information, see the "Assistance or Service" section of the Dryer User Instructions. Rigid metal vent For best drying performance, rigid metal vents are recommended. Rigid metal vent is recommended to - Whirlpool WED5510VQ | Installation Instructions - Page 12
offset elbow) B. Periscope installation NOTE: The following kits for close clearance alternate installations are available for purchase. Please see the "Assistance or Service" section of the Dryer User Instructions. Over-the-Top Installation: Part Number 4396028 Periscope Installation (For use with - Whirlpool WED5510VQ | Installation Instructions - Page 13
vent, because they can catch lint. Install Leveling Legs WARNING Excessive Weight Hazard Use two or more people to move and install dryer. Failure to do so a 4" (102 mm) clamp. 2. Move dryer into its final location. Do not crush or kink vent. 3. (On gas models) Check that there are no kinks in the - Whirlpool WED5510VQ | Installation Instructions - Page 14
side of hinges (C). Loosen (do not remove) top screws from cabinet side of hinges. 3. Lift door until top screws in cabinet are in large part of hinge slot. Pull door forward off screws. Set door on top of dryer. Remove top screws from cabinet. 4. Use a small, flat-blade screwdriver to gently remove - Whirlpool WED5510VQ | Installation Instructions - Page 15
not crushed or kinked. 5. Check that the dryer is level. See "Level Dryer." 6. In the U.S.A. For power supply cord installation, plug into an outlet. For direct wire installation, turn on power. In Canada Plug into a grounded 4 prong outlet. Turn on power. 7. Remove the blue protective film on the - Whirlpool WED5510VQ | Installation Instructions - Page 16
INSTRUCTIONS POUR L'INSTALLATION DE LA SÉCHEUSE ÉLECTRIQUE DE 29" (73,7 CM) SÉCURITÉ DE LA grave si vous ne suivez pas immédiatement les instructions. AVERTISSEMENT Risque possible de décès ou de blessure grave si vous ne suivez pas les instructions. Tous les messages de sécurité vous diront - Whirlpool WED5510VQ | Installation Instructions - Page 17
installations pour maison mobile nécessitent un système d'évacuation en métal qui peut être acheté chez le marchand chez qui vous avez acheté votre sécheuse. Pour plus d'information, veuillez consulter la section "Assistance ou service" des "Instructions robuste capable de supporter un poids total - Whirlpool WED5510VQ | Installation Instructions - Page 18
consulter les numéros de service qui se trouvent dans les Instructions d'utilisation de la sécheuse. INSTRUCTIONS DE LIAISON À LA TERRE courant, demander à un électricien qualifié d'installer une prise de courant appropriée. CONSERVEZ CES INSTRUCTIONS Risque de choc électrique Brancher sur une - Whirlpool WED5510VQ | Installation Instructions - Page 19
duire la capacité d'évacuation et le rendement. Ne pas installer le conduit métallique flexible dans les cavités fermées des couverture des Instructions pour l'utilisateur de la sécheuse. Pour plus de renseignements, voir la section "Assistance ou service" service" des "Instructions d'utilisation de - Whirlpool WED5510VQ | Installation Instructions - Page 20
où le dégagement est réduit. Veuillez consulter la section "Assistance ou service" dans les Instructions pour l'utilisateur de la sécheuse. Installation au-dessus de la sécheuse : Pièce numéro 4396028 Installation de périscope (pour l'utilisation en cas de nonconcordance de la bouche de - Whirlpool WED5510VQ | Installation Instructions - Page 21
des pieds de nivellement AVERTISSEMENT Risque du poids excessif Utiliser deux ou plus de personnes pour déplacer et installer la sécheuse. Le non-respect de cette instruction peut causer une blessure au dos ou d'autre blessure. 1. Pour protéger le sol, utiliser un grand morceau de l'emballage - Whirlpool WED5510VQ | Installation Instructions - Page 22
Mise à niveau de la sécheuse Contrôler l'aplomb de la sécheuse. Contrôler l'aplomb tout d'abord transversalement, puis dans le sens avant/arrière. Si la sécheuse n'est pas de niveau, la déposer sur un bloc de bois. Utiliser une clé à molette pour ajuster les pieds vers le haut ou vers le bas, et vé - Whirlpool WED5510VQ | Installation Instructions - Page 23
dans son logement pour ajuster l'alignement. Achever l'installation 1. Vérifier que toutes les pièces sont installées. S'il reste une pièce, passer la sécheuse. 8. Lire "Utilisation de la sécheuse" dans les Instructions pour l'utilisateur de la sécheuse. 9. Essuyer soigneusement le tambour de - Whirlpool WED5510VQ | Installation Instructions - Page 24
© 2008. All rights reserved. Tous droits réservés. TM DURASAFE is a trademark of Whirlpool, U.S.A., Whirlpool Canada LP Licensee in Canada TM DURASAFE est une marque de commerce de Whirlpool, U.S.A., Emploi licencié par Whirlpool Canada LP au Canada 11/08 Printed in U.S.A. Imprime aux É.-U.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
29" (73.7 CM) ELECTRIC DRYER
INSTALLATION INSTRUCTIONS
INSTRUCTIONS POUR L’INSTALLATION DE LA SÉCHEUSE
ÉLECTRIQUE DE 29" (73,7 CM)
Para obtener acceso al manual de uso y cuidado en español, o para obtener información adicional acerca de su producto, visite:
www.whirlpool.com.
Tenga listo su número de modelo completo. Puede encontrar el número de modelo y de serie dentro de la cavidad superior de la
puerta.
DRYER SAFETY
Table of Contents / Table des matières
DRYER SAFETY
...............................................
1
INSTALLATION INSTRUCTIONS
....................
2
Tools and Parts
.............................................
2
Location Requirements
................................
2
Electrical Requirements - U.S.A
. ..................
3
Electrical Requirements - Canada
................
5
Electrical Connection - U.S.A. Only
..............
6
Venting Requirements
.................................
11
Plan Vent System
........................................
12
Install Vent System
......................................
13
Install Leveling Legs
....................................
13
Level Dryer
..................................................
13
Connect Vent
...............................................
13
Reverse Door Swing (Optional)
...................
14
Complete Installation
..................................
15
SÉCURITÉ DE LA SÉCHEUSE
......................
16
INSTRUCTIONS D’INSTALLATION
...............
17
Outillage et pièces
.......................................
17
Exigences d’emplacement
..........................
17
Spécifications électriques- Canada
.............
18
Exigences concernant l'évacuation
.............
19
Planification du système d’évacuation
........
20
Installation du système d’évacuation
..........
21
Installation des pieds de nivellement
...........
21
Mise à niveau de la sécheuse
......................
22
Raccordement du conduit d’évacuation
.....
22
Inversion du sens d'ouverture de la
porte (facultatif)
............................................
22
Achever l’installation
....................................
23
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
W10150612B