Whirlpool WED5510VQ Installation Instructions - Page 11
Venting Requirements - review
View all Whirlpool WED5510VQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Venting Requirements WARNING Flexible metal vent Flexible metal vents are acceptable only if accessible for cleaning. Flexible metal vent must be fully extended and supported when the dryer is in its final location. Fire Hazard Use a heavy metal vent. Do not use a plastic vent. Do not use a metal foil vent. Remove excess flexible metal vent to avoid sagging and kinking that may result in reduced airflow and poor performance. Do not install flexible metal vent in enclosed walls, ceilings, or floors. The total length of flexible metal vent should not exceed 73⁄4 ft (2.4 m). Elbows Failure to follow these instructions can result in death or fire. 45° elbows provide better airflow than 90° elbows. WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED OUTDOORS. IMPORTANT: Observe all governing codes and ordinances. The dryer exhaust must not be connected into any gas vent, chimney, wall, ceiling, attic, crawlspace, or a concealed space of a building. If using an existing vent system Clean lint from the entire length of the system and make sure exhaust hood is not plugged with lint. Replace any plastic or metal foil vent with rigid or flexible heavy metal vent. Review Vent system chart. Modify existing vent system if necessary to achieve the best drying performance. Only rigid or flexible metal vent shall be used for exhausting. If this is a new vent system Vent material Use a heavy metal vent. Do not use plastic or metal foil vent. 4" (102 mm) heavy metal exhaust vent and clamps must be used. DURASAFE™ venting products are recommended. Good Better Clamps Use clamps to seal all joints. Exhaust vent must not be connected or secured with screws or other fastening devices that extend into the interior of the duct and catch lint. Do not use duct tape. Clamp Exhaust Recommended hood styles are shown here. B A 4" 102 mm 4" (102 mm) heavy metal exhaust vent DURASAFE™ vent products can be purchased from your dealer or by calling the toll-free number listed on the cover of the Dryer User Instructions. For more information, see the "Assistance or Service" section of the Dryer User Instructions. Rigid metal vent For best drying performance, rigid metal vents are recommended. Rigid metal vent is recommended to avoid crushing and kinking. 4" (102 mm) 4" (102 mm) A. Louvered hood style B. Box hood style The angled hood style (shown here) is acceptable. 4" (102 mm) 2½" (64 mm) 11