Whirlpool WED8200YW Installation Guide - Page 19

Reverse the strike 1. Remove the door strike from the dryer door opening. 2. Remove the cosmetic screw opposite the door strike. A B 4. Install the two hinges to the front panel of the dryer using 4 screws. Use the non-slotted side to attach the hinge to the front panel. 5. Install screws in top hinge holes in the door. Do not tighten screws. Leave approximately 1/4" (5 mm) of screw exposed. A . Door strike B. Cosmetic screw 3. Reinstall the door strike and cosmetic screw on the opposite side of dryer door opening from where they were removed. NOTE: Door strike and plugs must be on the same side of the dryer door opening. 6. Hang door by placing screw heads into top slotted holes of hinges and slide door down. Align bottom screw holes in hinge and door. Install two bottom screws. Tighten all hinge screws. Reinstall the door 1. Remove the 4 screws and two hinges from the dryer door. 2. Replace the 4 screws in the same holes 3. Remove the 4 screws from the opposite side of the door. 7. Close door to engage door strike. TROUBLESHOOTING DRYER OPERATION Dryer will not run ■■ Has a household fuse blown, or has a circuit breaker tripped? There may be two household fuses or circuit breakers for the dryer. Check that both fuses are intact and tight, or that both circuit breakers have not tripped. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. ■■ Is the correct power supply available? Electric dryers require a 240-volt power supply. Check with a qualified electrician. ■■ Was a regular fuse used? Use a time-delay fuse. 19