Whirlpool WED92HEFC Installation Guide - Page 20
Remove door from dryer, Move the door strike, Remove inner door from outer door, Remove hinge
View all Whirlpool WED92HEFC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Reverse door swing round-shaped door flat glass - double handle 1. Remove door from dryer 3. Remove inner door from outer door IMPORTANT: If the protective film has not yet been removed from the dryer, peel the film from the dryer door before proceeding. Using a T25® screwdriver, remove the 4 screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Reinstall the 4 screws in the holes. 2. Move the door strike Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 10 screws securing the inner door to the outer door. Lift off the inner door and set aside. 4. Remove hinge and latch Latch Using a T25® screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown. Hinge Using a T25® screwdriver, remove the 3 screws securing the latch plate and latch backing plate and the 5 screws holding the hinge assembly in place. 20