Whirlpool WFW9250WL Owners Manual - Page 14
Pausing or Restarting, Changing Cycles and Options, Status Lights, Cycles - washer manuals
UPC - 883049188126
View all Whirlpool WFW9250WL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Pausing or Restarting 1. To pause the washer at any time, press START/PAUSE. 2. To continue the cycle, press and hold START/PAUSE (for approximately 1 second). Changing Cycles and Options Not all Options are available with all Cycles. Cycles and Options can be changed anytime before START is pressed. To cancel a cycle 1. Press POWER. 2. The washer powers down, the door unlocks, and clothes can be removed. NOTE: If the water level or the temperature is too high, the washer will drain automatically before the door unlocks. To change Options after the cycle has started 1. Press START/PAUSE once. 2. Press the desired OPTIONS. If the option is not available, the machine will beep. 3. Press and hold START/PAUSE (for approximately 1 second) to continue the cycle. NOTE: Press OPTIONS button until TumbleFresh light glows to add periodic tumbling after the wash cycle is finished. The light will glow when this option is selected and will remain flashing for up to 6 hours or until the washer is stopped by either pressing POWER or opening the door. To drain the washer manually 1. Press START/PAUSE. 2. Press RINSE/DRAIN & SPIN. 3. Deselect EXTRA RINSE option. 4. Press and hold START/PAUSE (for approximately 1 second) to begin the drain. 5. When the spin is complete, the door unlocks. Items can be removed from the washer. Status Lights These lights show which portion of the cycle the washer is operating. They also indicate when you can add an additional item to the wash cycle and when the controls are locked. Done The Done light comes on after the cycle is complete. The light will stay on until door is opened. Locking controls The Control Lock avoids unintended use of the washer. You can also use the control lock feature to avoid unintended cycle or option changes during a cycle. When CONTROL LOCK is lit, all buttons are disabled except for START/PAUSE, POWER, and SIGNAL. You can lock the controls while the washer is operating. To lock the controls Press and hold SIGNAL for 3 seconds. The CONTROL LOCK status light illuminates. To unlock the controls Press and hold SIGNAL for 3 seconds until the CONTROL LOCK Status light turns off. Estimated Time Remaining The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load. The cycle time will be extended if oversudsing occurs or the load is unbalanced. The options you select will also change the cycle times that are shown in the Factory Default Cycle Settings table. The Estimated Time Remaining can change up to 30 minutes under extreme conditions. Door Locked When the status light illuminates, the door is locked. The door is locked and unlocked automatically, depending on the stage of the wash cycle. Cycles Wash Cycles Choose Wash Cycles by rotating the Cycle selector knob to the desired cycle. The indicator light for the cycle selected will illuminate. Each cycle is designed for different types of fabric and soil levels. Adding items You can add items to the washer after the wash cycle has started, if the Add a Garment status light is illuminated. All cycles have this feature except Rinse/Drain & Spin, and Clean Washer with AFFRESH™ cycle. To add items 1. Press START/PAUSE. The washer door unlocks, and items can be added. 2. To continue the cycle, close the door and press and hold START/PAUSE (for approximately 1 second). NOTE: To add garments after the Add a Garment period is over, the wash cycle needs to be canceled, the items added, and a new wash cycle started. 14 ■ Each cycle has a preset cycle time. TEMP and SPIN SPEED may have preset Options. The preset settings provide the recommended fabric care for the selected cycle.