Whirlpool WMH1162XVD Installation Instructions
Whirlpool WMH1162XVD - 1.6 cu. ft. Microwave-Range Hood Combination Manual
 |
UPC - 883049147901
View all Whirlpool WMH1162XVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WMH1162XVD manual content summary:
- Whirlpool WMH1162XVD | Installation Instructions - Page 1
the Microwave Oven 9. Complete Installation 1.0 VENTING DESIGN SPECIFICATIONS 1. 1 ASSISTANCE 1..2 Replacement Parts 1..2 Accessories 1..2 MICROWAVEHOODCOMBINATIOSNAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and - Whirlpool WMH1162XVD | Installation Instructions - Page 2
, see "Replacement Parts" section. NOTE: The hardware items listed here are for wood studs. For other types of wall structures, be sure to use appropriate fasteners. A Check the opening where the microwave oven will be installed. The location must provide: • Minimum installation dimensions. See - Whirlpool WMH1162XVD | Installation Instructions - Page 3
30" (76.2 cm) is typical for 66" (167.6 cm) installation height. Exact dimensions may vary depending on type of range/cooktop below. T 171/4" (43 8 crn' T 16¼" 111.3 cm) GROUNDING iNSTRUCTiONS [] For all cord connected appliances: The microwave oven must be grounded. In the event of an electrical - Whirlpool WMH1162XVD | Installation Instructions - Page 4
Remove the mounting plate by peeling off the strips of tape that attach it to the back of the microwave oven, and set the mounting plate aside. The microwave oven is set for recirculation installation. For wall or roof venting, changes must be made to the venting system. NOTE: Skip this section if - Whirlpool WMH1162XVD | Installation Instructions - Page 5
motor is not positioned with flat sides facing the back of the microwave oven (as shown), performance will be poor. 6. Reattach blower motor to back of microwave oven with 2 screws removed in Step 3 of "Wall Venting Installation Only." Securely tighten screws. NOTE: If blower motor is not correctly - Whirlpool WMH1162XVD | Installation Instructions - Page 6
These depictions show examples of preferred installation configurations with the mounting plate. 6" (15.2 cm) of the vertical centerline (see "Mark Rear Wall" section), only recirculation or roof venting installation can be done. Wall Studs at Both Corner Holes Figure 4 i i i i i i i i i - Whirlpool WMH1162XVD | Installation Instructions - Page 7
mark the vertical centerline of the opening. A ....._..i._../.L..i.-._..°....I.II_ Wall Venting Installation Only Centerline Upper cabinet bottom f 4" (10.2crn) %" (1 cm) I A. Centerline 2. With the support tabs facing forward (see illustrations in "Possible Wall Stud Configurations" in - Whirlpool WMH1162XVD | Installation Instructions - Page 8
3) 1. With the support tabs of the mounting in the top of the microwave oven. // // .// guides. 4. Make sure the 10" (25.4 cm) dimension from the rear wall to points "D" and "E" on the template is maintained. 5. Insert lag screw(s) into the holes drilled into wall stud(s) in Step 2 of "Installation - Whirlpool WMH1162XVD | Installation Instructions - Page 9
needs to be installed around the supply cord hole, as shown. B Excessive Weight Hazard Use two or more people to move and install microwave oven. Failure to 2 sheet metal screws. A. Mounting plate B. Support tabs 4= With front of microwave oven still tilted, thread power supply cord through the - Whirlpool WMH1162XVD | Installation Instructions - Page 10
. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. Check that the power supply cord is plugged into a grounded 3 prong outlet. See the Use and Care Guide for troubleshooting information. Installation is now complete. Save Installation Instructions for - Whirlpool WMH1162XVD | Installation Instructions - Page 11
VENTINGDESIGNSPECIFICATIONS This section is intended for architectural designer and builder/contractor reference only. NOTES: • Vent materials needed for installation are not provided with microwave hood. We do not recommend using a flexible metal vent. To avoid possible product damage, be sure to - Whirlpool WMH1162XVD | Installation Instructions - Page 12
this microwave oven in a 36" (91.4 cm) or 42" (106.7 cm) wide opening. The filler panels come in pairs. Each panel is 3" (7.6 cm) wide. If any of the installation hardware needs to be replaced, call us at our toll free number listed in the Use and Care Guide, and reference the appropriate part
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
MICROWAVE
HOOD
COMBINATION
INSTALLATIONINSTRUCTIONS
This product
is suitable for use above electric or gas cooking
products
up to and including
36" (91.4 cm) wide. See "Installation
Requirements"
section for further
notes.
These installation
instructions
cover different models.
The appearance
of your particular
model may differ slightly from the illustration
in
these installation
instructions.
Tableof Contents
MICROWAVE HOOD COMBINATION SAFETY
.............................
1
INSTALLATION REQUIREMENTS
..................................................
2
Tools and Parts
..............................................................................
2
Location Requirements
..................................................................
2
Product Dimensions
......................................................................
3
Electrical Requirements
.................................................................
3
INSTALLATION INSTRUCTIONS
....................................................
4
Remove Mounting Plate
................................................................
4
Rotate Blower Motor
......................................................................
4
Locate Wall Stud(s)
........................................................................
6
Mark RearWall
...............................................................................
7
Drill Holes in RearWall
...................................................................
7
Attach Mounting Plate to Wall
.......................................................
8
Prepare Upper Cabinet
..................................................................
8
Install DamperAssembly
...............................................................
9
Install the Microwave Oven
...........................................................
9
Complete Installation
...................................................................
10
VENTING DESIGN SPECIFICATIONS
...........................................
11
ASSISTANCE
..................................................................................
12
Replacement Parts
......................................................................
12
Accessories
..................................................................................
12
MICROWAVEHOOD
COMBINATION
SAFETY
Your safety and the safety of others are very important.
We have provided
many important
safety messages
in this manual and on your appliance.
Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol
alerts you to potential
hazards that can kill or hurt you and others.
All safety
messages
will follow the safety alert symbol and either the word "DANGER"
or "WARNING."
These words mean:
You can be killed or seriously
injured if you don't immediately
follow
instructions.
You can be killed or seriously
injured
if you don't
follow
instructions.
All safety messages
will tell you what the potential
hazard is, tell you how to reduce the chance
of injury, and tell you what can
happen
if the instructions
are not followed.
W10189505A