Whirlpool WMH32517AW Installation Instructions

Whirlpool WMH32517AW Manual

Whirlpool WMH32517AW manual table of contents:

  • Whirlpool WMH32517AW | Installation Instructions - Page 1
    ...Attach Mounting Plate to Wall ...8 Prepare Upper Cabinet...8 Install Damper Assembly ...9 Install the Microwave ... ...10 VENTING DESIGN SPECIFICATIONS...11 ASSISTANCE ...12 Replacement Parts ...12 Accessories...... provided many important safety messages in this manual and on your appliance. Always read ...
  • Whirlpool WMH32517AW | Installation Instructions - Page 2
    ... types of wall structures, be sure to use appropriate fasteners. ■ NOTES: ■ If installing the microwave... template Mounting plate (attached to back of microwave oven) Cardboard template (part of packaging... (Depending on model, charcoal filters may not be included. See User Instructions.) For Roof...
  • Whirlpool WMH32517AW | Installation Instructions - Page 3
    ... an extension cord. Failure to follow these instructions can result in death, fire, or electrical ... only this microwave oven. A. 2" x 4" wall stud B. Grounded 3 prong outlet GROUNDING INSTRUCTIONS ■ *30... must be plugged into an outlet that is properly installed and grounded. 17¹⁄₄" (43.8 cm...
  • Whirlpool WMH32517AW | Installation Instructions - Page 4
    INSTALLATION INSTRUCTIONS 4. Lift blower motor out of microwave oven. Remove Mounting Plate Depending on your model, the mounting plate may be in the foam packaging, or it may be attached to ... wall or roof venting may be used. A Wall Venting Installation Only 1. Remove screws attaching ...
  • Whirlpool WMH32517AW | Installation Instructions - Page 5
    ... oven. Lower blower motor back into microwave oven. A 6. Reattach blower motor to back of microwave oven with 2 screws removed in Step 3 of "Wall Venting Installation Only."... tabs are inserted into the slots in the top of the microwave oven. A B C D A. Damper plate B. Screws C. Damper ...
  • Whirlpool WMH32517AW | Installation Instructions - Page 6
    ... opening, do not install the microwave oven. See illustrations in "Possible Wall Stud Configurations... Studs at End Holes Figure 1 No Wall Studs at End Holes Figure 2 B C C D A E B A E F C D A E A E F NOTE:... stud centerlines D. Holes for lag screws E. Support tabs F. Mounting plate center markers...
  • Whirlpool WMH32517AW | Installation Instructions - Page 7
    Mark Rear Wall The microwave oven must be installed on a minimum of 1 wall stud, preferably 2, using ... the bottom edge of the cardboard template. These represent the mounting plate's end holes and bottom edge. ...-head bolts with toggle nuts; if 1 end hole is over a wall stud, use 1 lag screw and one ...
  • Whirlpool WMH32517AW | Installation Instructions - Page 8
    ...-head bolt through the end hole that fits over the 3/4" (19 mm) hole drilled in Step 3 ... 1 wall stud as well as at both ends. 1. With the support tabs of the mounting plate facing forward, insert 1/4-... trim lines to use as guides. ■ If the wall behind the microwave oven (as installed) has a partial ...
  • Whirlpool WMH32517AW | Installation Instructions - Page 9
    ... installed around the supply cord hole, as shown. Install the Microwave Oven B WARNING Excessive Weight ... microwave oven and hang it on support tabs at the bottom of mounting plate. NOTE: To avoid damage to... easily into the vent in the wall cutout. 6. Push microwave oven against mounting plate and ...
  • Whirlpool WMH32517AW | Installation Instructions - Page 10
    ...downward. Using 2 or more people, lift microwave oven off of mounting plate, and set ...and retighten screws. 9. Repeat steps 3-6. 10. With the microwave oven centered, and with at least one ... 3 prong outlet. See the User Instructions for troubleshooting information. Installation is now complete. Save ...
  • Whirlpool WMH32517AW | Installation Instructions - Page 11
    .... NOTES: ■ Vent materials needed for installation are not provided with microwave hood combination. ■ ■ Rectangular ... air outside, unless using recirculation installation. Do not vent exhaust air...) high 3" (7.6 cm) E F If venting through the wall, be sure that there is proper clearance within...
  • Whirlpool WMH32517AW | Installation Instructions - Page 12
    ... straight vent, elbow(s), transitions and wall or roof caps must not exceed ... User Instructions. Accessories Filler Panel Kits are available from your dealer to use when installing this microwave ... in the User Instructions. Following is a list of available replacement parts. You will need your model ...



Type your new search above

The manual viewer requires the flash plugin to be installed and enabled.
To view this page ensure that Adobe Flash Player version 10 or greater is installed.

Whirlpool WMH32517AW Manual