Whirlpool WOC97ES0ES Installation Guide - Page 7
Install Oven, Install Warming Drawer Deflector Kit, Only for Ovens Installed Above Warming, Drawers - wall oven
View all Whirlpool WOC97ES0ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
1. Connect the 2 black wires (C) together using a UL-listed wire connector. 2. Connect the 2 white wires (D) and the green (or bare) ground wire (of the oven cable) using a UL-listed wire connector. 3. Connect the 2 red wires (G) together using a UL-listed wire connector. 4. Install junction box cover. Install Oven 1. Using 2 or more people, lift oven partially into cabinet cutout. Use the oven opening as an area to grip. NOTE: Push against seal area of oven front frame when pushing oven into cabinet. Do not push against outside edges. 5. T he bottom vent is shipped in the foam packing at the top of the oven. Install the bottom vent (C) as follows: ■ Align vent tab (B) with oven frame (A) as shown. ■ Using one #8-18 x ³⁄8" screw (D) on each side of the vent tab (B), fasten the vent securely to the oven. A B 2. Push against the seal area of the front frame to push the oven into the cabinet until the back surface of the front frame touches the front wall of the cabinet. D A. Oven frame B. Vent tab C C. Bottom vent D. #8-18 x ³⁄8" screws 6. R eplace oven racks. 7. R eplace the oven door. See the "Replace Oven Door(s)" section. 8. C heck that door is free to open and close. If it is not, repeat the removal and installation procedures. See "Prepare Built-In Microwave/Oven Combination" section. 9. Reconnect power. 10. T he display panel will light briefly, and "PF" should appear in the display. 11. If the display panel does not light, please reference the "Warranty" section of the Use and Care Guide. 3. Push oven completely into cabinet and center oven into cabinet cutout. 4. Remove the tape from black front trims. ■ Securely fasten the oven to the cabinet using the #8-14 x ¾" screws provided. ■ Insert the screws through holes in black trim aligning with holes in oven frame. Do not overtighten screws. A Install Warming Drawer Deflector Kit (Only for Ovens Installed Above Warming Drawers) On combo microwave/oven models installed above a warming drawer, a warming drawer deflector kit must be installed. See the "Tools and Parts" section for ordering information. Parts Supplied A B C A. Oven frame B. Oven frame hole C. Black trim piece B A. Phillips head screws (4) only 2 screws for 27" (68.6 cm) size B. Warming drawer deflector (1) 7