Whirlpool WOES5030LW Dimension Guide - Page 2

DIMENSION GUIDE Location Requirements IMPORTANT: Observe all governing codes and ordinances. ■ Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance with oven. ■ Recessed installation area must provide complete enclosure around the recessed portion of the oven. ■ Grounded electrical supply is required. See "Electrical Requirements" section. ■ Electrical supply junction box should be located 3" (7.6 cm) maximum below the support surface when the oven is installed in a wall cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box. NOTE: For undercounter installation, it is recommended that the junction box be located in the adjacent right or left cabinet. If you are installing the junction box on rear wall behind oven, it is recommended that the junction box be recessed and located in the upper center of the cabinet. ■ Oven support surface must be solid, level and flush with bottom of cabinet cutout. ■ Floor must be able to support a single oven weight of 200 lbs (91 kg) for 30" (76.2 cm) models. IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C). 2 of 18 Product Dimensions - Single Ovens, Standard Installation B G F C A D E 30" (76.2 cm) models A. 29" (73.6 cm) maximum overall height B. 287⁄16" (72.2 cm) maximum recessed width C. 26" (65.9 cm) recessed height D. 231⁄4" (59.1 cm) maximum recessed depth E. 293⁄4" (75.6 cm) overall width F. 12" (30.5 cm) from back of control panel to start of strain relief G. 48" (121.9 cm) flexible conduit length