Whirlpool WRF757SDEM Use & Care Guide - Page 33
Temperature and Moisture
View all Whirlpool WRF757SDEM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
TR O U B L E S H O O T I N G PROBLEM Popping Hissing/Dripping Vibration Rattling/Banging Sizzling Water running/Gurgling Buzzing and Clicking Repetitive Clicking Creaking/Cracking/Grinding Clatter POSSIBLE CAUSES SOLUTIONS Contraction/expansion of inside walls, especially during initial cool-down This is normal. Flow of refrigerant, or flow of oil in the compressor This is normal. The refrigerator may not be steady Adjust the leveling screws and lower the leveling foot firmly against the floor. See "Refrigerator Leveling, Door Closing and Alignment." Movement of the water lines against the refrigerator cabinet, or of items placed on top of the refrigerator cabinet Move excess water line away from the refrigerator cabinet or fasten excess tubing to the cabinet. See "Connecting the Water," or remove items from the top of the refrigerator. Water dripping on the heater during defrost cycle This is normal. May be heard when ice melts during the defrost cycle and water runs into the drain pan This is normal. Heard when the water valve opens and closes to dispense water and/or fill the ice maker If the refrigerator is connected to a water line, this is normal. If the refrigerator is not connected to a water line, turn OFF the ice maker. Dual evaporator valve regulating the cooling operation You may hear rapid repetitive clicking sounds as the unit switches from cooling one compartment to cooling the other. This sound is normal. May be heard as ice is being ejected from the ice maker mold This is normal. May be heard when the ice falls into the ice storage bin This is normal. Temperature and Moisture PROBLEM POSSIBLE CAUSES SOLUTIONS Temperature is too warm The refrigerator has just been installed. Allow 24 hours following installation for the refrigerator to cool completely. Cooling is turned off. Turn on cooling. See "Using the Control(s)." The controls are not set correctly for Adjust the controls a setting colder. Check the temperature in the surrounding conditions. 24 hours. See "Using the Control(s)." The door(s) are opened often or not closed completely. Allows warm air to enter refrigerator. Minimize door openings and keep doors fully closed. A large load of food was recently added. Allow several hours for refrigerator to return to normal temperature, or see "Using the Control(s)" for information about how to speed up the cooling process (on some models). Temperature is too cold The refrigerator air vent(s) are blocked. If the air vent located in the top, left, rear corner of the refrigerator in the refrigerator/ compartment is blocked by items placed directly in front of it, the crisper refrigerator will get too cold. Move items away from the air vent. The controls are not set correctly for Adjust the controls a setting warmer. Check the temperature in the surrounding conditions. 24 hours. See "Using the Control(s)." The ice storage bin is not in the correct position. See "Ice Maker and Ice Storage Bin." Temperature is too cold The control is not set correctly for the Adjust the temperature setting. See "Temperature Controlled in the pantry drawers items stored in drawer. Drawer" in the "Refrigerator Features" section. 33