Whirlpool WRS965CIAE Installation Guide - Page 4

Opening Dimensions ■ Height dimensions are shown with the leveling legs extended to the minimum height of ¹⁄₄" (6.35 mm) below the refrigerator. NOTE: When leveling legs are fully extended to 1" (25 mm) below the refrigerator, add ³⁄₄" (19 mm) to the height dimensions. ■ In the following graphic, "A" represents the opening height required for standard cabinets. For full-overlay cabinet doors with a trim kit, add ¹⁄₈" (0.3 cm). ■ In the following graphic, "B" represents the distance needed to fully open the freezer door and "C" represents the distance needed to fully open the refrigerator door. Door Swing Dimensions ■ Location must permit doors to open to a minimum of 165°. ■ In the following graphic, "A" represents the distance needed to fully open the freezer door and "B" represents the distance needed to fully open the refrigerator door. 41¹⁄₄" (104.5 cm) A C D 45⁷⁄₈" (116.4 cm) B C D 90˚ 165˚ 36" (91.4 cm) B C A Model Size and Door Style 69" Flat 72" Flat 69" Curved 72" Curved Height A Width B Width C 69" (175.3 cm) 72" (182.9 cm) 69" (175.3 cm) 72" (182.9 cm) 13⁵⁄₈" (34.5 cm) maximum* 13⁵⁄₈" (34.5 cm) maximum* 13³⁄₄" (34.9 cm) 13³⁄₄" (34.9 cm) 18¹⁄₈" (46.0 cm) maximum* 18¹⁄₈" (46.0 cm) maximum* 18³⁄₈" (46.4 cm) 18³⁄₈" (46.4 cm) *Dimension may vary based on style of door handle. The width for the largest available handle is listed. 4 Dimension A B C D Flat Doors 13⁵⁄₈" (34.5 cm) maximum* 18¹⁄₈" (46.0 cm) maximum* 2³⁄₄" (6.7 cm) maximum* ¹⁄₈" (0.2 cm) Curved Doors 13³⁄₄" (34.9 cm) 18³⁄₈" (46.4 cm) 3³⁄₄" (9.4 cm) 1¹⁄₄" (2.9 cm) *Dimension may vary based on style of door handle. The width for the largest available handle is listed. Location Requirements WARNING Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from refrigerator. Failure to do so can result in death, explosion, or fire. NOTES: ■ The cabinet depth refrigerator can be installed into a recessed opening, at the end of cabinets or as a freestanding refrigerator. ■ If you are installing the refrigerator to fit flush with the front of the base cabinets, all shoe molding and baseboards must be removed from the rear of the refrigerator opening. Allow for 1" (2.54 cm) of space behind the refrigerator. ■ Location should permit doors to open fully. See the "Door Swing Dimensions" section. ■ Do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C). ■ Floor must support refrigerator weight (more than 600 lbs [272 kg], door panels and contents).