Whirlpool WRS973CIDM Use & Care Guide - Page 15

2. Press and hold the OPTIONS and LOCK buttons at the same time for 3 seconds. The words "Back" and "1 Cup" will appear on the display screen. Also, "CALIBRATE" will illuminate and remain lit while the Measured Fill feature is being calibrated. NOTE: You may press the ICE TYPE button under the word "Back" at any time to exit calibration mode. The display screen's "CALIBRATE" text will turn off. 3. Using your hand (not the measuring cup), press and release the water dispenser pad in order to dispense water to the 1 cup fill line. NOTE: If overfilling or spilling occurs, discard the water and press "Back" to restart the calibration process. 4. When 1 cup of water has been correctly dispensed into the measuring cup, press the MEASURED FILL button under the word "Confirm" to confirm the calibration. When Measured Fill calibration has been confirmed, the display will return to the home screen. The Water Dispenser IMPORTANT: ■ Dispense at least 1 qt (1 L) of water every week to maintain a fresh supply. ■ If the flow of water from the dispenser decreases, it could be caused by low water pressure. ■ With the water filter removed, dispense 1 cup (237 mL) of water. If 1 cup of water is dispensed in 8 seconds or less, the water pressure to the refrigerator meets the minimum requirement. ■ If it takes longer than 8 seconds to dispense 1 cup of water, the water pressure to the refrigerator is lower than recommended. See "Water Supply Requirements" or "Troubleshooting" or "Problem Solver" for suggestions. To Dispense Water (Standard): 1. Press a sturdy glass against the water dispenser pad. Hold the glass close to the water dispenser spout to ensure that the water dispenses into the glass. A A. Water dispenser spout NOTE: While dispensing water and for 3 seconds after dispensing has stopped, the digital display will show how much water has been dispensed. 2. Remove the glass to stop dispensing. To Dispense Water (Measured Fill): Measured Fill allows you to dispense a specified amount of water with the touch of a few buttons. NOTE: The amount of water you select will be dispensed. Be sure that the container is empty and can hold the entire volume. If ice is in the container, you may need to adjust your selection. IMPORTANT: Low water pressure may affect the accuracy of this feature. 1. Press MEASURED FILL to turn the feature on. When the feature is on, the Measured Fill screen appears on the display. Press ICE TYPE to manually turn off the Measured Fill feature. NOTE: The dispenser will automatically turn off Measured Fill after 1 minute of inactivity. When Measured Fill is turned off, any changes you have made will be lost and all defaults will be restored. 2. You can dispense water by the ounce, cup, or liter. The default unit is ounces. To switch to cups or liters, press the LIGHT button. Default, minimum, and maximum volumes are listed below. Units Ounces Cups Liters Default 8 1 0.25 Minimum 1 ¹/₄ 0.05 Maximum 128 16 4.00 3. Press the LOCK and OPTIONS buttons to adjust the volume as desired. The LOCK button increases the volume, and the OPTIONS button lowers the volume. NOTES: ■ When increasing or decreasing the volume, the control may stop responding if an adjustment button is held for approximately 10 seconds or longer. Release the button for approximately 2 seconds, then continue making adjustments. 15