Whirlpool WRT111SFAB Installation Guide - Page 8

Adjust the Doors WARNING Excessive Weight Hazard Use two or more people to move and install refrigerator. Failure to do so can result in back or other injury. Your refrigerator has two adjustable levelers, one on each side, at the base of the refrigerator. If your refrigerator seems unsteady or if you want the doors to close more easily, adjust the level and tilt of the refrigerator. 1. Turn the leveler to the left to raise that side of the refrigerator or to the right to lower that side. It may take several turns to adjust the tilt of the refrigerator. NOTE: Having someone push against the top of the refrigerator takes some weight off the levelers. This makes it easier to turn the levelers. 2. Open both doors again to make sure that they close as easily as you like. If not, tilt the refrigerator slightly more to the rear by turning both levelers to the right. It may take several more turns. NOTE: To keep the refrigerator level, make the same adjustment to each side. 3. Using a level, make sure the refrigerator is still level from side to side. Readjust if necessary. REFRIGERATOR FEATURES Your model may have some or all of these features. Important information to know about glass shelves and covers: Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. Tempered glass is designed to shatter into many small, pebble-size pieces. This is normal. Glass shelves and covers are heavy. Use both hands when removing them to avoid dropping. Refrigerator Shelves (Glass shelves on some models) The shelves in your refrigerator are adjustable to match your individual storage needs. Storing similar food items together in your refrigerator and adjusting the shelves to fit different heights of items will make finding the exact item you want easier. It will also reduce the amount of time the refrigerator door is open, and save energy. Shelves and Glass Shelves (on some models) To remove and replace a shelf: 1. Remove items from the shelf. 2. Slide the shelf straight out to the stop. 3. Depending on your model, lift back or front of the shelf past the stop. Slide shelf out the rest of the way. 4. Replace the shelf by sliding the back of the shelf into the track in the wall of the cabinet. 5. Guide the front of the shelf into the shelf track. Be sure to slide the shelf in all the way. Meat Drawer (on some models) To remove and replace the meat drawer: 1. Slide meat drawer out to the stop. 2. Lift front of meat drawer with one hand while supporting bottom of drawer with other hand. Slide drawer out the rest of the way. 3. Replace the drawer by sliding it back in fully past the drawer stop. Meat Drawer Cover (on some models) To remove and replace the meat drawer cover: 1. Remove the meat drawer. 2. Push the cover back to release the rear clips from the shelf. Tilt the cover up at the front, and pull it forward. 3. Replace the meat drawer cover by fitting the notches and clips on the cover over the rear and center crossbars on the shelf. 4. Lower cover into place and pull the cover forward to secure the rear clips onto the shelf. 5. Replace the meat drawer. NOTE: In some models the meat pan moves sideways on the shelf to allow for flexible positioning. 8