Whirlpool WRT138FFD Dimension Guide - Page 1
Whirlpool WRT138FFD Manual
View all Whirlpool WRT138FFD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
G F Cabinet E Not Including Handle D Including Handle B 4 Top of Cabinet 1 Top Mount Refrigerator A Overall Height C 90˚ Model Number WRT108FFD WRT138FFD WRT148FZD WRT318FZD WRT318FMD WRT519SZD WRT549SZD Model Size 18.2 cu ft 19.2 cu ft Reversible Door Height Overall "A" Height - Top of Cabinet "B" Depth - Door Open 90° "C" Depth - With Handles "D" Depth - Without Depth - Cabinet Width - Cabinet Handles "E" Only "F" "G" Yes 657/8" (1673 mm) 653/8" (1660 mm) 593/4" (1518 mm) 331/2" (850 mm) 313/8" (797 mm) 287/8" (733 mm) 293/4" (756 mm) Yes 657/8" (1673 mm) 653/8" (1660 mm) 597/8" (1520 mm) 341/2" (876 mm) 327/8" (835 mm) 287/8" (733 mm) 293/4" (756 mm) ELECTRICAL REQUIREMENTS WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Electrical: A 115 V, 60 Hz, AC only, 15 A or 20 A fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending on the model) to the desired setting. See "Using the Controls." Water: A cold water supply with water pressure between 30 psi and 120 psi (207 kPa and 827 kPa) is required to operate ice maker and water dispenser. If you have questions about your water pressure, call a licensed, qualified plumber. IMPORTANT: The pressure of the water coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 psi and 120 psi (207 kPa and 827 kPa). Reverse Osmosis Water Supply: If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 psi to 60 psi (276 kPa to 414 kPa). W11558135A 1