Whirlpool WSF26D2EXB Use & Care Guide - Page 5

6. Replace the refrigerator door by lifting the door onto the bottom right hinge. 7. Align and replace the top right hinge as shown. See Graphic 6. Tighten screws. 8. Replace the ice storage bin and any adjustable door or utility bins. 9. Plug refrigerator into a grounded 3 prong outlet. Leveling and Door Closing Your refrigerator has two adjustable front feet - one on the right and one on the left. In most cases, the refrigerator should be steady when both feet are touching the floor. If your refrigerator seems unsteady or if you want the doors to close more easily, adjust the refrigerator's tilt using the instructions below: 1. Move the refrigerator into its final location. If necessary, open both doors to 90° and remove the base grille. See Graphic 1. 2. The two leveling feet are located on the brackets on each side of the product. See Graphic 8. NOTE: Having someone push against the top of the refrigerator takes some weight off the leveling feet. This makes it easier to make adjustments. 3. Use a ¹⁄₄" open-ended or adjustable wrench to adjust the leveling feet. Turn the leveling foot to the left to raise that side of the product, or turn it to the right to lower that side of the product. 4. Open both doors again and check that they close as easily as you like. If not, tilt the refrigerator slightly more to the rear by turning the leveling feet to the left. It may take several more turns, and you should turn both leveling feet the same amount. NOTE: Whenever you need to move the refrigerator, turn the leveling feet to the right until they are no longer touching the ground. This will allow the refrigerator to roll more easily. Door Alignment A refrigerator that is not level from side-to-side may appear to have doors that are not properly aligned. If the doors appear this way, use the instructions in the previous section to check the leveling. The doors are designed to be slightly different heights when the refrigerator is empty, in order to account for the weight of food that will be placed on the doors. If the doors are still not aligned after checking the leveling and loading the refrigerator with food, follow the steps below to adjust the door alignment. 1. If necessary, open both doors to 90° and remove the base grille. See Graphic 1. 2. Locate the alignment screw on the bottom hinge of the refrigerator door. See Graphic 9. 3. Use a open-ended or adjustable wrench to turn the screw. To raise the refrigerator door, turn the screw to the right. To lower the door, turn the screw to the left. 4. Check that the doors are even at the top. If necessary, continue to turn the alignment screw until the doors are aligned. 5. Open both doors to 90°. Replace the base grille. See Graphic 1. Handle Installation and Removal Style 1 - Setscrews PARTS INCLUDED: Door handles (2 hex key, spare setscrew(s) To Install the Handles: NOTE: The handle mounting setscrews are preinstalled in the handle. 1. Remove the handles, which are packed inside the refrigerator. NOTE: To avoid scratching the finish, place the handles on a towel or other soft surface. 2. Open the freezer door. On the refrigerator door, place the handle on the shoulder screws with the setscrews facing the freezer. A B A. Shoulder screws B. Setscrews inside the handle 3. Firmly push the handle toward the door until the handle base is flush against the door. 4. While holding the handle, insert the short end of the hex key into the upper hole and slightly rotate the hex key until it is engaged in the setscrew. 5. Using a clockwise motion, tighten the setscrew until it begins to contact the shoulder screw. 6. Repeat steps 4 and 5 to begin fastening the lower setscrew. 5