Whirlpool WSR57R18DM Use & Care Guide - Page 5
Refrigerator Leveling and Door Closing
View all Whirlpool WSR57R18DM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Handle B A C Door Removal and Replacement Top Hinge A B B C A. Top Hinge Cover B. 5/16" Hex-Head Hinge Screws C. Top Hinge A. Grommet B. Handle C. Setscrews Bottom Hinge A B A. Hinge Pin B. 3/8" Hex-Head Hinge Screws Refrigerator Leveling and Door Closing Your refrigerator has two front adjustable legs, one on each side. The back of the refrigerator rests on two fixed rollers. The base grille covers the adjustable brake feet and roller assemblies located at the bottom of the refrigerator below the refrigerator door. Before making any adjustments, remove the base grille and move the refrigerator to its final location. Tools Needed: ¹⁄₄" hex driver, Phillips screwdriver 1. Remove the base grille screws. Grasp the grille firmly and pull it toward you. Open the refrigerator door to access the brake feet. NOTE: To allow the refrigerator to roll more easily, raise the brake feet by turning them counterclockwise. The front rollers will be touching the floor. 2. Move the refrigerator to its final location. 3. Lower the brake feet, by turning them clockwise, until the rollers are off the floor and both brake feet are snug against the floor. This keeps the refrigerator from rolling forward when opening the refrigerator door. IMPORTANT: If you need to make further adjustments involving the brake feet, you must turn both brake feet the same amount to keep the refrigerator level. 4. Make sure the door closes easily. If you are satisfied with the door opening and closing, skip the next section. If, however, the door does not close easily or the door pops open, adjust the tilt. 5