Xerox 6180N DocuSP 4.1 to 4.2 Differences - Page 8

Imposition/Layout enhancements

Get Xerox 6180N - Phaser Color Laser Printer PDF manuals and user guides
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

Imposition/Layout enhancements DocuSP 4.2 provides the user with a new template, the Z-sort template. In addition, the Z-sort, or ZIP-sort capability has been extended to all multiple-up options. This addition allows multiple-up (e.g. 4-up, 6-up, 9-up, etc.) to be cut and then stacked in a predefined order so that postal sort order is maintained. See the figure below. Detail shot of new Cut and Stack control in the Layout FAB The output may be either single-sided or double-sided, and the layout numbers, as is suggested by the layout example shown above, the pages and images appropriately so that the order is maintained when cut and stacked. As a specific example of N-up imposition, consider the 2-Up case. 2-Up Flip right can be programmed by selecting "Repeated" and by checking the "Flip Right" box. In a similar fashion, the legacy 2-Up Cut and Stack option can be programmed by selecting "Cut and Stack" and checking the "Cut On Binding Edge" box. 4 DocuSP 3.8 and 4.0 to 4.1 Differences Document

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
Imposition/Layout enhancements
DocuSP 4.2 provides the user with a new template, the
Z-sort template.
In addition, the Z-sort, or ZIP-sort
capability has been extended to all multiple-up options.
This addition allows multiple-up (e.g. 4-up, 6-up, 9-up,
etc.) to be cut and then stacked in a predefined order
so that postal sort order is maintained. See the figure
below.
Detail shot of new Cut and Stack control in the Layout FAB
The output may be either single-sided or double-sided,
and the layout numbers, as is suggested by the layout
example shown above, the pages and images
appropriately so that the order is maintained when cut
and stacked.
As a specific example of N-up imposition, consider the
2-Up case.
2-Up Flip right can be programmed by
selecting “Repeated” and by checking the “Flip Right”
box. In a similar fashion, the legacy 2-Up Cut and
Stack option can be programmed by selecting “Cut and
Stack” and checking the “Cut On Binding Edge” box.
4
DocuSP 3.8 and 4.0 to 4.1 Differences Document