Xerox 8560DN Instructions for Supplies - Page 21

Phaser® Printer Scanner Calibration Instructions Perform the scanner calibration procedure if your scanner, document feeder, or document cover is replaced. Scanner calibration adjusts the output quality of the front and back pages of 2-sided originals in relation to each other. This procedure should not be performed as part of normal system operation. Calibrate the scanner using the Scanner Calibration page that came with your replacement scanner, document feeder, or document cover. After you begin the calibration procedure at the control panel, calibrate the scanner using a two-step process: ■ The first step scans the calibration page from the document glass. Follow the steps in the Document Glass section. (For systems without a document feeder, only use the steps in this section to calibrate the scanner.) ■ The second step scans the calibration page through the document feeder. Follow the steps in the Document Feeder section. Starting the Calibration Procedure 1. On the control panel, press the System button. 2. Select Information, and then press the OK button. 3. Select Troubleshooting, and then press the OK button. 4. Select Service Tools, and then press the OK button. 5. Select Calibrate Scanner, and then press the OK button. Continue with the Document Glass steps. Document Glass 1. Place the Scanner Calibration page on the document glass, with the top edge of the page toward the left. Note: Make sure the calibration page is aligned correctly. If the page is misaligned, the calibration procedure will fail. Copyright © 2007, 2006 Xerox Corporation. All Rights Reserved. 1 of 2 www.xerox.com/support 075-1018-01 Rev A