Yamaha A-S700 Owner's Manual - Page 6

Front panel CONTROLS AND FUNCTIONS 1 POWER Press inward to the ON position to turn on the power of this unit. You can set this unit to standby mode by pressing button on the remote control or turn on the unit by pressing button on the remote control when this unit is turned on. Press again to release it outward to the OFF position to turn off this unit. Note Even when this unit is turned off, this unit consumes a small amount of power to preserve the memory. 2 POWER on indicator Lights up as follows: ON: Bright Standby mode: Dark OFF: Off 3 Remote control sensor Receives signals from the remote control. 4 INPUT selector and indicators Select the input source you want to listen to. The input source indicators light up when the corresponding input sources are selected. y The input source names correspond to the names of the connection jacks on the rear panel. Note The input setting is retained for about 1 week after the power cable is unplugged. 5 PHONES jack Connect headphones for private listening. Rotate the SPEAKERS selector on the front panel to the OFF position to turn off the sound from the speakers. 6 SPEAKERS selector Turn on or off the speaker set connected to the SPEAKERS A and/or B terminals on the rear panel each time the corresponding SPEAKERS selector is set to A, B or A+B. 7 REC OUT selector Select a source for recording independently of the INPUT selector setting, allowing you to record the selected source while listening to another source. See page 11 for details. 8 BASS Increase or decrease the low frequency response. See page 10 for details. 9 TREBLE Increase or decrease the high frequency response. See page 10 for details. 0 BALANCE Adjust the sound output balance of the left and right speakers. See page 10 for details. A LOUDNESS Retain a full tonal range at any volume level. See page 11 for details. B CD DIRECT AMP and indicator Reproduces CD sound in the highest signal quality regardless of the INPUT selector setting. The indicator above it lights up when this function is turned on. See page 10 for details. 2 En