Yamaha AX 596 MCXSP10 Manual

Yamaha AX 596 - Amplifier Manual

Get Yamaha AX 596 - Amplifier PDF manuals and user guides View all Yamaha AX 596 manuals
Add to My Manuals
Save this manual to your list of manuals

Yamaha AX 596 manual content summary:

  • Yamaha AX 596 | MCXSP10 Manual - Page 1
    U C A AX-596 STEREO AMPLIFIER AMPLIFICATEUR STEREO OWNER'S MANUAL MODE D'EMPLOI I
  • Yamaha AX 596 | MCXSP10 Manual - Page 2
    16 Servicing - The user should not attempt to service the unit beyond those means described in the operating instructions. All other servicing should be referred to qualified service personnel. 17 Power Lines - An outdoor antenna should be located away from power lines. 18 Grounding or Polarization
  • Yamaha AX 596 | MCXSP10 Manual - Page 3
    problem by using one Utilize power outlets instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. The above statements apply ONLY to those products distributed by Yamaha sounds is often undetectable until it is too late, YAMAHA
  • Yamaha AX 596 | MCXSP10 Manual - Page 4
    After unpacking, check that the following items are contained. Après le déballage, vérifier que les pièces suivantes sont incluses. q Remote control q Télécommande STANDBY/ON DECK A/B TAPE DIR A DIR B DISC SKIP CD - PRESET + A/B/C/D/E TUNER MD TAPE CD/DVD AUX PHONO TUNER - VOLUME
  • Yamaha AX 596 | MCXSP10 Manual - Page 5
    for selecting this YAMAHA stereo amplifier. FEATURES ⅷ 100W + 100W (8Ω) RMS Output Power, 0.015% THD, 20-20,000 Hz ⅷ Highly Dynamic Power, Low Impedance Drive Capability ⅷ Continuously Variable LOUDNESS Control ⅷ CD/DVD DIRECT AMP Switch Used to Reproduce the Purest CD and DVD Sound ⅷ PURE DIRECT
  • Yamaha AX 596 | MCXSP10 Manual - Page 6
    accidents. YAMAHA will not be to read the "TROUBLESHOOTING" section regarding common panel or the remote control, the STANDBY power supply is completely cut off. (U.S.A. model) R R L B SPEAKERS L A CAUTION SEE INSTRUCTION MANUAL FOR CORRECT SETTING. IMPEDANCE SELECTOR SET BEFORE POWER
  • Yamaha AX 596 | MCXSP10 Manual - Page 7
    ● Use AA, R6, UM-3 batteries. ● Be sure the polarities are correct. (See the illustration inside the battery compartment.) ● Remove the batteries if the remote control is not used for an extended period of time. ● If batteries leak, dispose of them immediately. Avoid touching the leaked material and
  • Yamaha AX 596 | MCXSP10 Manual - Page 8
    CONTROLS AND THEIR FUNCTIONS FRONT PANEL 1 23 4 5 6 STANDBY POWER ON OFF NATURAL SOUND STEREO AMPLIFIER AX-596 AUX MD TAPE CD/DVD TUNER PHONO STANDBY/ON PHONES SPEAKERS A B ON OFF BASS l 0l 2 2 3 3 4 5 4 5 TREBLE l 0l 2 2 3 3 4 5 4 5 BALANCE l 0l 2 2 3 3 4
  • Yamaha AX 596 | MCXSP10 Manual - Page 9
    the switch outward (OFF) for the speakers you do not use. 0 Tone controls BASS Rotate this knob to increase or decrease the low frequency response. The 0 the left and right speakers can be adjusted to compensate for sound imbalances caused by the speaker location or listening room conditions. B
  • Yamaha AX 596 | MCXSP10 Manual - Page 10
    a very small quantity of power to receive infrared-signals from the remote control. 2 Input selector keys Press control other YAMAHA components are the same as the corresponding keys on those components. Refer to those components' instruction manuals for details. 1 Tape deck keys These keys control
  • Yamaha AX 596 | MCXSP10 Manual - Page 11
    the owner's manual for each of your components. ● Use RCA type pin plug cables for audio/video units except speakers. ● The output (or input) terminals of YAMAHA INSTRUCTION MANUAL FOR CORRECT SETTING. IMPEDANCE SELECTOR SET BEFORE POWER amplifier when connecting to these terminals. E-7
  • Yamaha AX 596 | MCXSP10 Manual - Page 12
    (keep it as short as possible). If the connections are faulty, no sound will be heard from the speakers. Make sure that the + and - polarity the speaker wires are observed and set correctly. If these wires are reversed, the sound will be unnatural and lack bass. ● One or two speaker systems can be
  • Yamaha AX 596 | MCXSP10 Manual - Page 13
    PRE OUT/MAIN IN terminals enables this unit to operate separately as a control amplifier and a power amplifier. These terminals are used for connecting a signal-processing system such as a graphic equalizer or a surround-sound processor to this unit. If such an external unit is connected to these
  • Yamaha AX 596 | MCXSP10 Manual - Page 14
    /ON to turn on the power. (The STANDBY indicator turns off.) STANDBY/ON STANDBY/ON - + STANDBY POWER Turns off. 4 Select the Adjust the tonal quality by using the BASS, TREBLE, BALANCE, LOUDNESS controls, the CD/DVD DIRECT AMP switch or the PURE DIRECT switch. (Refer to page 12). When you
  • Yamaha AX 596 | MCXSP10 Manual - Page 15
    a source to tape (or MD) 4, 6, 7 STANDBY POWER ON OFF STANDBY/ON AUX MD TAPE CD/DVD TUNER PHONO PHONES sound output. 2 4 5 Begin recording on the tape deck (or MD recorder). 6 The sound BASS, TREBLE, BALANCE, LOUDNESS controls, the CD/DVD DIRECT AMP switch and the PURE DIRECT switch
  • Yamaha AX 596 | MCXSP10 Manual - Page 16
    INPUT selector, the BASS, TREBLE, BALANCE, LOUDNESS controls and the PRE OUT/MAIN IN terminals, and then sent to the power amplifier. This signal routing reproduces the purest sound eliminating any alterations to the CD or DVD signals. CD/DVD DIRECT AMP Using the PURE DIRECT switch You can enjoy
  • Yamaha AX 596 | MCXSP10 Manual - Page 17
    English TROUBLESHOOTING Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instructions given below do not help, disconnect the power cord and contact your authorized YAMAHA dealer or service center. Problem The
  • Yamaha AX 596 | MCXSP10 Manual - Page 18
    Power (EIAJ) (1 kHz, 10% THD) 8/6 145/170W Dynamic Power (IHF) 8/6/4/2 140/170/220/290W DIN Standard Output Power (4Ω, 1 kHz, 0.7% THD 155W IEC Output Power (8Ω, 1 kHz, 0.015% THD 110W Power lbs. 5 oz.) Accessories Remote control Batteries Specifications subject to change without notice. E-14
  • Yamaha AX 596 | MCXSP10 Manual - Page 19
    ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VASTRA FRÖLUNDA, SWEDEN
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
AX-596
STEREO AMPLIFIER
AMPLIFICATEUR STEREO
OWNER’S MANUAL
MODE D’EMPLOI
U C A